Re: [PATCH 6/7] pinctrl: ds90ux9xx: add TI DS90Ux9xx pinmux and GPIO controller driver

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

Hi Vladimir,

thanks for your patch! Some review comments:

On Mon, Oct 8, 2018 at 11:12 PM Vladimir Zapolskiy <vz@xxxxxxxxx> wrote:

> From: Vladimir Zapolskiy <vladimir_zapolskiy@xxxxxxxxxx>
>
> The change adds an MFD cell driver for managing pin functions on
> TI DS90Ux9xx de-/serializers.
>
> Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy@xxxxxxxxxx>

Please mention in the commit that you are also adding a GPIO
chip driver.

> +// SPDX-License-Identifier: GPL-2.0-or-later

I prefer the simple "GPL-2.0+" here.

> +#include <linux/of_gpio.h>

You should not need this include. If you do, something is wrong.

> +#define SER_REG_PIN_CTRL               0x12
> +#define PIN_CTRL_RGB18                 BIT(2)
> +#define PIN_CTRL_I2S_DATA_ISLAND       BIT(1)
> +#define PIN_CTRL_I2S_CHANNEL_B         (BIT(0) | BIT(3))
> +
> +#define SER_REG_I2S_SURROUND           0x1A
> +#define PIN_CTRL_I2S_SURR_BIT          BIT(0)
> +
> +#define DES_REG_INDIRECT_PASS          0x16
> +
> +#define OUTPUT_HIGH                    BIT(3)
> +#define REMOTE_CONTROL                 BIT(2)
> +#define DIR_INPUT                      BIT(1)
> +#define ENABLE_GPIO                    BIT(0)
> +
> +#define GPIO_AS_INPUT                  (ENABLE_GPIO | DIR_INPUT)
> +#define GPIO_AS_OUTPUT                 ENABLE_GPIO
> +#define GPIO_OUTPUT_HIGH               (GPIO_AS_OUTPUT | OUTPUT_HIGH)
> +#define GPIO_OUTPUT_LOW                        GPIO_AS_OUTPUT
> +#define GPIO_OUTPUT_REMOTE             (GPIO_AS_OUTPUT | REMOTE_CONTROL)

These have a creepily generic look, like they hit the global GPIO
namespace without really clashing. It gets confusing when reading
the code.

Do you think you could prefix them with DS90_* or something
so it is clear that these defines belong in this driver?

> +static const struct gpio_chip ds90ux9xx_gpio_chip = {
> +       .owner                  = THIS_MODULE,
> +       .get                    = ds90ux9xx_gpio_get,
> +       .set                    = ds90ux9xx_gpio_set,
> +       .get_direction          = ds90ux9xx_gpio_get_direction,
> +       .direction_input        = ds90ux9xx_gpio_direction_input,
> +       .direction_output       = ds90ux9xx_gpio_direction_output,
> +       .base                   = -1,
> +       .can_sleep              = 1,

This is bool so set it = true;

Overall it's a very nice driver. It is pretty complex but pin control
is complex so that's a fact of life.

Yours,
Linus Walleij