Current code assumes that the direction is input if direction_input function is set. This might not be the case on GPIOs with programmable direction. Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@xxxxxxxxx> --- drivers/gpio/gpiolib.c | 33 +++++++++++++++++++-------------- 1 file changed, 19 insertions(+), 14 deletions(-) diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c index 6925196136ce..eaadbcb5c0f8 100644 --- a/drivers/gpio/gpiolib.c +++ b/drivers/gpio/gpiolib.c @@ -1344,20 +1344,6 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data, spin_unlock_irqrestore(&gpio_lock, flags); - for (i = 0; i < chip->ngpio; i++) { - struct gpio_desc *desc = &gdev->descs[i]; - - desc->gdev = gdev; - - /* REVISIT: most hardware initializes GPIOs as inputs (often - * with pullups enabled) so power usage is minimized. Linux - * code should set the gpio direction first thing; but until - * it does, and in case chip->get_direction is not set, we may - * expose the wrong direction in sysfs. - */ - desc->flags = !chip->direction_input ? (1 << FLAG_IS_OUT) : 0; - } - #ifdef CONFIG_PINCTRL INIT_LIST_HEAD(&gdev->pin_ranges); #endif @@ -1374,6 +1360,25 @@ int gpiochip_add_data_with_key(struct gpio_chip *chip, void *data, if (status) goto err_remove_irqchip_mask; + for (i = 0; i < chip->ngpio; i++) { + struct gpio_desc *desc = &gdev->descs[i]; + + desc->gdev = gdev; + + /* REVISIT: most hardware initializes GPIOs as inputs (often + * with pullups enabled) so power usage is minimized. Linux + * code should set the gpio direction first thing; but until + * it does, and in case chip->get_direction is not set, we may + * expose the wrong direction in sysfs. + */ + if (chip->get_direction && gpiochip_line_is_valid(chip, i)) + desc->flags = !chip->get_direction(chip, i) ? + (1 << FLAG_IS_OUT) : 0; + else + desc->flags = !chip->direction_input ? + (1 << FLAG_IS_OUT) : 0; + } + status = gpiochip_add_irqchip(chip, lock_key, request_key); if (status) goto err_remove_chip; -- 2.19.0