On Tue, Jan 16, 2018 at 02:45:08PM +0200, Baruch Siach wrote: > The Raspberry Pi 3 GPIO expander is controlled by the VC4 firmware over > I2C. The firmware mailbox interface allows the ARM core to control the > GPIO lines. > > Signed-off-by: Baruch Siach <baruch@xxxxxxxxxx> > --- > v3: > * Rename node name. > > v2: > * Rename compatible string to raspberrypi,firmware-gpio > --- > .../bindings/gpio/raspberrypi,firmware-gpio.txt | 24 ++++++++++++++++++++++ > 1 file changed, 24 insertions(+) > create mode 100644 Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt > > diff --git a/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt b/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt > new file mode 100644 > index 000000000000..936dc59eba12 > --- /dev/null > +++ b/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt > @@ -0,0 +1,24 @@ > +Raspberry Pi GPIO expander > + > +The Raspberry Pi 3 GPIO expander is controlled by the VC4 firmware. The > +firmware exposes a mailbox interface that allows the ARM core to control the > +GPIO lines on the expander. > + > +Required properties: > + > +- compatible : Should be "raspberrypi,firmware-gpio" > +- gpio-controller : Marks the device node as a gpio controller > +- #gpio-cells : Should be two. The first cell is the pin number, and > + the second cell is used to specify the gpio polarity: > + 0 = active high > + 1 = active low > +- firmware : Reference to the RPi firmware device node > + > +Example: > + > +expgpio: gpio-expander { Still not right. The correct generic node name is "gpio". > + compatible = "raspberrypi,firmware-gpio"; > + gpio-controller; > + #gpio-cells = <2>; > + firmware = <&firmware>; Can you make this a child of the firmware node instead? Rob -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html