This driver has no business including <linux/gpio.h>, it is a driver so include <linux/gpio/driver.h>. GPIOF_DIR_IN/GPIOF_DIR_OUT are for consumers and should not be used in drivers to use just 1/0 instead. Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> --- drivers/gpio/gpio-bcm-kona.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/gpio/gpio-bcm-kona.c b/drivers/gpio/gpio-bcm-kona.c index dfcf56ee3c61..f4c793e9a92b 100644 --- a/drivers/gpio/gpio-bcm-kona.c +++ b/drivers/gpio/gpio-bcm-kona.c @@ -17,7 +17,7 @@ #include <linux/bitops.h> #include <linux/err.h> #include <linux/io.h> -#include <linux/gpio.h> +#include <linux/gpio/driver.h> #include <linux/of_device.h> #include <linux/of_irq.h> #include <linux/init.h> @@ -127,7 +127,7 @@ static int bcm_kona_gpio_get_dir(struct gpio_chip *chip, unsigned gpio) u32 val; val = readl(reg_base + GPIO_CONTROL(gpio)) & GPIO_GPCTR0_IOTR_MASK; - return val ? GPIOF_DIR_IN : GPIOF_DIR_OUT; + return !!val; } static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value) @@ -144,7 +144,7 @@ static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value) raw_spin_lock_irqsave(&kona_gpio->lock, flags); /* this function only applies to output pin */ - if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN) + if (bcm_kona_gpio_get_dir(chip, gpio) == 1) goto out; reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id); @@ -170,7 +170,7 @@ static int bcm_kona_gpio_get(struct gpio_chip *chip, unsigned gpio) reg_base = kona_gpio->reg_base; raw_spin_lock_irqsave(&kona_gpio->lock, flags); - if (bcm_kona_gpio_get_dir(chip, gpio) == GPIOF_DIR_IN) + if (bcm_kona_gpio_get_dir(chip, gpio) == 1) reg_offset = GPIO_IN_STATUS(bank_id); else reg_offset = GPIO_OUT_STATUS(bank_id); -- 2.14.3 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html