Hi, A few weeks ago, I have sent an RFC about adding bias support for GPIOs [1]. It was motivated by the fact that I wanted to enable the pinmuxing strict mode for my pin controller which can muxed a pin as a peripheral or as a GPIO. Enabling the strict mode prevents several devices to be probed because requesting a GPIO fails. The pin request function complains about the ownership of the GPIO which is different from the mux ownership. I have to remove my pinctrl node to avoid this conflict but I need it to configure my pins and to set a pull-up bias for my GPIOs. My first idea was to add new flags in addition to GPIO_ACTIVE_HIGH and others. Obviously, it was not the way to go since many new flags may be added: strength, debounce, etc. Then I proposed a very "quick and dirty" patch to give the picture of what I have in mind but I had no feedback. It was probably too dirty. The idea was to add a cell to the gpios property with a phandle on a pinctrl node which contains only the pinconf, no pinmux. The configuration is applied later when requesting the GPIO. The main issue is that enabling the strict mode will break old DTBs. I was going to submit patches for this but, after using the sysfs which still show me a bad ownership, I decided that it should be fixed. So I did these patches. Unfortunately, there are several ways to lead to gpiod_request(). It does the trick only for the gpiod_get family. The issue is still present with legacy gpio_request and fwnode_get_named_gpiod. It seems that more and more drivers are converted to use GPIO descriptors so there is some hope. The advantage of this solution is to not break old DTBs. As I am not aware of all usage of the gpiolib, I tried to implement it in the safest way. Regards Ludovic [1] https://www.spinics.net/lists/arm-kernel/msg623149.html Ludovic Desroches (2): pinctrl: add consumer variant for gpio request gpio: provide a consumer when requesting a gpio drivers/gpio/gpiolib.c | 40 +++++++++++++++++++++++++++++++++------- drivers/pinctrl/core.c | 13 ++++++++++--- drivers/pinctrl/pinmux.c | 16 ++++++++++++++-- drivers/pinctrl/pinmux.h | 10 ++++++++++ include/linux/gpio/driver.h | 5 +++++ include/linux/pinctrl/consumer.h | 6 ++++++ 6 files changed, 78 insertions(+), 12 deletions(-) -- 2.12.2 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html