Re: [PATCH V1 1/2] pinctrl: qcom: spmi-gpio: Read REG_EN_CTL to get initial enable state

[Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>]

On Thu 12 Oct 23:15 PDT 2017, fenglinw@xxxxxxxxxxxxxx wrote:

> From: Fenglin Wu <fenglinw@xxxxxxxxxxxxxx>
> 
> Get initial value of is_enabled flag by reading REG_EN_CTL register
> so that it can reflect the correct hardware enable state before
> setting pin config.
> 
> Signed-off-by: Fenglin Wu <fenglinw@xxxxxxxxxxxxxx>
> ---
>  drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 9 +++++++--
>  1 file changed, 7 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
> index a0edaa8..0a1e173 100644
> --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
> +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
> @@ -106,6 +106,7 @@
>  
>  /* PMIC_GPIO_REG_EN_CTL */
>  #define PMIC_GPIO_REG_MASTER_EN_SHIFT		7
> +#define PMIC_GPIO_REG_MASTER_EN			0x80
>  
>  #define PMIC_GPIO_PHYSICAL_OFFSET		1
>  
> @@ -914,8 +915,12 @@ static int pmic_gpio_populate(struct pmic_gpio_state *state,
>  		pad->atest = (val & PMIC_GPIO_LV_MV_ANA_MUX_SEL_MASK) + 1;
>  	}
>  
> -	/* Pin could be disabled with PIN_CONFIG_BIAS_HIGH_IMPEDANCE */
> -	pad->is_enabled = true;
> +	val = pmic_gpio_read(state, pad, PMIC_GPIO_REG_EN_CTL);
> +	if (val < 0)
> +		return val;
> +
> +	pad->is_enabled = val & PMIC_GPIO_REG_MASTER_EN;

Please be more explicit here: is_enable = !!(val & ...)

> +

other than that,

Acked-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>

Regards,
Bjorn
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html