Configuration of the lcd0 pinmux group and GPIO hog for the external GPIO mux are done using a single device node, causing the "output-high" property to be applied to both. This will fail for the pinmux group, but doesn't cause any harm, as the failure is ignored silently. However, after "pinctrl: sh-pfc: propagate errors on group config", the failure will become fatal, leading to a broken display: sh-pfc e6050000.pin-controller: pin_config_group_set op failed for group 102 sh-pfc e6050000.pin-controller: Error applying setting, reverse things back sh-pfc e6050000.pin-controller: failed to select default state Move the GPIO hog to its own node to fix this. Fixes: ffd2f9a5afb730b9 ("ARM: shmobile: armadillo800eva dts: Add pinctrl and gpio-hog for lcdc0") Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> --- This is a hard dependency for "pinctrl: sh-pfc: propagate errors on group config" (https://patchwork.kernel.org/patch/9186713/). v2: - Keep the GPIO hog, but move it to its own node, instead of using another level of subnodes. As the GPIO hog node is not referenced from a pinctrl-0 property, pinconf doesn't fail with "No pin or group provided in DT node". --- arch/arm/boot/dts/r8a7740-armadillo800eva.dts | 2 ++ 1 file changed, 2 insertions(+) diff --git a/arch/arm/boot/dts/r8a7740-armadillo800eva.dts b/arch/arm/boot/dts/r8a7740-armadillo800eva.dts index 297b1f10f7346a9f..8c85d3ee5f5e7bfd 100644 --- a/arch/arm/boot/dts/r8a7740-armadillo800eva.dts +++ b/arch/arm/boot/dts/r8a7740-armadillo800eva.dts @@ -273,7 +273,9 @@ lcd0_pins: lcd0 { groups = "lcd0_data24_0", "lcd0_lclk_1", "lcd0_sync"; function = "lcd0"; + }; + lcd0_mux { /* DBGMD/LCDC0/FSIA MUX */ gpio-hog; gpios = <176 0>; -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html