Re: [PATCH RfC v4 3/6] dt-bindings: add Amlogic Meson GPIO interrupt-controller DT binding documentation

[Neil Armstrong <narmstrong@xxxxxxxxxxxx>]

On 05/28/2017 09:11 PM, Heiner Kallweit wrote:
> Add dt binding documentation for Amlogic meson GPIO interrupt controller.
> 
> Signed-off-by: Heiner Kallweit <hkallweit1@xxxxxxxxx>
> ---
>  .../amlogic,meson-gpio-intc.txt                    | 26 ++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/interrupt-controller/amlogic,meson-gpio-intc.txt
> 
> diff --git a/Documentation/devicetree/bindings/interrupt-controller/amlogic,meson-gpio-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/amlogic,meson-gpio-intc.txt
> new file mode 100644
> index 00000000..2f20d212
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/interrupt-controller/amlogic,meson-gpio-intc.txt
> @@ -0,0 +1,26 @@
> +Amlogic meson GPIO interrupt controller
> +
> +Meson SoCs contains an interrupt controller which is able watch the SoC pads
> +and generate an interrupt on edges or level. The controller is essentially a
> +256 pads to 8 GIC interrupt multiplexer, with a filter block to select edge
> +or level and polarity. The actual number of interrupt exposed depends on the
> +SoC.
> +
> +Required properties:
> +
> +- compatible : should be "amlogic,meson-gpio-intc".
> +- reg : Specifies base physical address and size of the registers.
> +- interrupt-controller : Identifies the node as an interrupt controller.
> +- #interrupt-cells : should be 2.
> +- parent-interrupts : list of GIC interrupts which can be used with the
> +		      GPIO IRQ multiplexer
> +
> +Example:
> +
> +gpio_intc: interrupt-controller@9880 {
> +	compatible = "amlogic,meson-gpio-intc";
> +	reg = <0x0 0x09880 0x0 0x10>;
> +	interrupt-controller;
> +	#interrupt-cells = <2>;
> +	parent-interrupts = <64 65 66 67 68 69 70 71>;
> +};
> 

Looks good.

Reviewed-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html