Re: [PATCH 1/1] gpio: core: Decouple open drain/source flag with active low/high

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Thu, Apr 6, 2017 at 3:35 PM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote:

> Currently, the GPIO interface is said to Open Drain if it is Single
> Ended and active LOW. Similarly, it is said as Open Source if it is
> Single Ended and active HIGH.
>
> The active HIGH/LOW is used in the interface for setting the pin
> state to HIGH or LOW when enabling/disabling the interface.
>
> In Open Drain interface, pin is set to HIGH by putting pin in
> high impedance and LOW by driving to the LOW.
>
> In Open Source interface, pin is set to HIGH by driving pin to
> HIGH and set to LOW by putting pin in high impedance.
>
> With above, the Open Drain/Source is unrelated to the active LOW/HIGH
> in interface. There is interface where the enable/disable of interface
> is ether active LOW or HIGH but it is Open Drain type.
>
> Hence decouple the Open Drain with Single Ended + Active LOW and
> Open Source with Single Ended + Active HIGH.
>
> Adding different flag for the Open Drain/Open Source which is valid
> only when Single ended flag is enabled.
>
> Signed-off-by: Laxman Dewangan <ldewangan@xxxxxxxxxx>

Patch applied.

Good that you found this and fixed it before someone git hurt.

Sorry for screwing it up, my fault.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html