Re: [PATCH 2/2] iio: misc: add support for GPIO power switches

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sun, Dec 11, 2016 at 11:21 PM, Bartosz Golaszewski
<bgolaszewski@xxxxxxxxxxxx> wrote:

> Some power-measuring ADCs work together with power load switches which
> allow to power-cycle measured devices.
>
> An example use case would be measuring the power consumption of a
> development board during boot using a power monitor such as TI INA226
> and power-cycling the board remotely using a TPS229* power switch.
>
> Add an iio driver for simple GPIO power switches and expose a sysfs
> attribute allowing to toggle their state.
>
> Signed-off-by: Bartosz Golaszewski <bgolaszewski@xxxxxxxxxxxx>

I don't get this, isn't this doing the same as
drivers/power/reset/gpio-poweroff.c
?

With the only difference that the latter uses the standard syscall
from pm_power_off to reboot the system instead of some random
sysfs file.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux