Re: [PATCH 1/2] pinctrl: tegra: Add DT binding for io pads control

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Wed, Nov 2, 2016 at 10:09 AM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote:

> NVIDIA Tegra124 and later SoCs support the multi-voltage level and
> low power state of some of its IO pads. The IO pads can work in
> the voltage of the 1.8V and 3.3V of IO power rail sources. When IO
> interface are not used then IO pads can be configure in low power
> state to reduce the power from that IO pads.
>
> On Tegra124, the IO power rail source is auto detected by SoC and hence
> it is only require to configure in low power mode if IO pads are not
> used.
>
> On T210 onwards, the auto-detection is removed from SoC and hence SW
> must configure the PMC register explicitly to set proper voltage in
> IO pads based on IO rail power source voltage.
>
> Add DT binding document for detailing the DT properties for
> configuring IO pads voltage levels and its power state.
>
> Signed-off-by: Laxman Dewangan <ldewangan@xxxxxxxxxx>
(...)

> +-nvidia,power-source-voltage:  Integer. The voltage level of IO pads. The
> +                               valid values are 1.8V and 3.3V. Macros are
> +                               defined for these voltage levels in
> +                               <dt-bindings/pinctrl/pinctrl-tegra-io-pad.h>
> +                               Use TEGRA_IO_PAD_POWER_SOURCE_1800000UV for 1.8V
> +                               Use TEGRA_IO_PAD_POWER_SOURCE_3300000UV for 3.3V
> +
> +                               All IO pads do not support the 1.8V/3.3V
> +                               configurations. Valid values for "pins" are
> +                               audio-hv, dmic, gpio, sdmmc1, sdmmc3, spi-hv.


As mentioned in another patch, what is wrong with the standard
power-source binding?

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html