Re: [PATCH 3/6] gpio: gpio-cbc: Document bindings of CBC FPGA GPIO block

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Fri, Oct 7, 2016 at 5:20 PM, Pantelis Antoniou
<pantelis.antoniou@xxxxxxxxxxxx> wrote:

> From: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
>
> Add device tree bindings document for the GPIO driver of
> Juniper's CBC FPGA.
>
> Signed-off-by: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
> [Ported from Juniper kernel]
> Signed-off-by: Pantelis Antoniou <pantelis.antoniou@xxxxxxxxxxxx>
> ---
>  .../devicetree/bindings/gpio/jnx,gpio-cbc.txt      | 30 ++++++++++++++++++++++
>  1 file changed, 30 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt
>
> diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt
> new file mode 100644
> index 0000000..d205d0b
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt
> @@ -0,0 +1,30 @@
> +Juniper CBC FPGA GPIO block
> +
> +Required properties:
> +
> +- compatible:
> +    Must be "jnx,cbc-gpio"
> +
> +Optional properties:
> +
> +- reg:
> +    Address and length of the register set for the device. This is optional since
> +    usually the parent MFD driver fills it in.
> +
> +- #gpio-cells:
> +    Should be <2>.  The first cell is the pin number (within the controller's
> +    pin space), and the second is used for the following flags:
> +       bit[0]: direction (0 = out, 1 = in)
> +       bit[1]: init high
> +       bit[2]: active low

Can't you just refer to the generic bindings?

Apart from that it looks fine.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html