Re: [RESEND v2 07/10] gpio: stmpe: rework registers access

[Lee Jones <lee.jones@xxxxxxxxxx>]

On Wed, 10 Aug 2016, patrice.chotard@xxxxxx wrote:

> From: Patrice Chotard <patrice.chotard@xxxxxx>
> 
> This update allows to use registers map as following :
> regs[reg_index + offset] instead of
> regs[reg_index] + offset
> 
> This makes code clearer and will facilitate the addition of STMPE1600
> on which LSB and MSB registers are respectively located at addr and addr + 1.
> Despite for all others STMPE variant, LSB and MSB registers are respectively
> located in reverse order at addr + 1 and addr.
> 
> For variant which have 3 registers's bank, we use LSB,CSB and MSB indexes
> which contains respectively LSB (or LOW), CSB (or MID) and MSB (or HIGH)
> register addresses (STMPE1801/STMPE24xx).
> For variant which have 2 registers's bank, we use LSB and CSB indexes only.
> In this case the CSB index contains the MSB regs address (STMPE 1601).
> 
> Signed-off-by: Patrice Chotard <patrice.chotard@xxxxxx>
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> ---
>  drivers/gpio/gpio-stmpe.c | 48 ++++++++++++++++++++++++++---------------------
>  1 file changed, 27 insertions(+), 21 deletions(-)

Applied, thanks.

> diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
> index 2789bdc..6d6d76a 100644
> --- a/drivers/gpio/gpio-stmpe.c
> +++ b/drivers/gpio/gpio-stmpe.c
> @@ -21,6 +21,8 @@
>   */
>  enum { REG_RE, REG_FE, REG_IE };
>  
> +enum { LSB, CSB, MSB };
> +
>  #define CACHE_NR_REGS	3
>  /* No variant has more than 24 GPIOs */
>  #define CACHE_NR_BANKS	(24 / 8)
> @@ -40,7 +42,7 @@ static int stmpe_gpio_get(struct gpio_chip *chip, unsigned offset)
>  {
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
> -	u8 reg = stmpe->regs[STMPE_IDX_GPMR_LSB] - (offset / 8);
> +	u8 reg = stmpe->regs[STMPE_IDX_GPMR_LSB + (offset / 8)];
>  	u8 mask = 1 << (offset % 8);
>  	int ret;
>  
> @@ -56,7 +58,7 @@ static void stmpe_gpio_set(struct gpio_chip *chip, unsigned offset, int val)
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
>  	int which = val ? STMPE_IDX_GPSR_LSB : STMPE_IDX_GPCR_LSB;
> -	u8 reg = stmpe->regs[which] - (offset / 8);
> +	u8 reg = stmpe->regs[which + (offset / 8)];
>  	u8 mask = 1 << (offset % 8);
>  
>  	/*
> @@ -74,7 +76,7 @@ static int stmpe_gpio_direction_output(struct gpio_chip *chip,
>  {
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
> -	u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8);
> +	u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB + (offset / 8)];
>  	u8 mask = 1 << (offset % 8);
>  
>  	stmpe_gpio_set(chip, offset, val);
> @@ -87,7 +89,7 @@ static int stmpe_gpio_direction_input(struct gpio_chip *chip,
>  {
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
> -	u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8);
> +	u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB + (offset / 8)];
>  	u8 mask = 1 << (offset % 8);
>  
>  	return stmpe_set_bits(stmpe, reg, mask, 0);
> @@ -157,10 +159,16 @@ static void stmpe_gpio_irq_sync_unlock(struct irq_data *d)
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(gc);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
>  	int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8);
> -	static const u8 regmap[] = {
> -		[REG_RE]	= STMPE_IDX_GPRER_LSB,
> -		[REG_FE]	= STMPE_IDX_GPFER_LSB,
> -		[REG_IE]	= STMPE_IDX_IEGPIOR_LSB,
> +	static const u8 regmap[CACHE_NR_REGS][CACHE_NR_BANKS] = {
> +		[REG_RE][LSB] = STMPE_IDX_GPRER_LSB,
> +		[REG_RE][CSB] = STMPE_IDX_GPRER_CSB,
> +		[REG_RE][MSB] = STMPE_IDX_GPRER_MSB,
> +		[REG_FE][LSB] = STMPE_IDX_GPFER_LSB,
> +		[REG_FE][CSB] = STMPE_IDX_GPFER_CSB,
> +		[REG_FE][MSB] = STMPE_IDX_GPFER_MSB,
> +		[REG_IE][LSB] = STMPE_IDX_IEGPIOR_LSB,
> +		[REG_IE][CSB] = STMPE_IDX_IEGPIOR_CSB,
> +		[REG_IE][MSB] = STMPE_IDX_IEGPIOR_MSB,
>  	};
>  	int i, j;
>  
> @@ -178,7 +186,7 @@ static void stmpe_gpio_irq_sync_unlock(struct irq_data *d)
>  				continue;
>  
>  			stmpe_gpio->oldregs[i][j] = new;
> -			stmpe_reg_write(stmpe, stmpe->regs[regmap[i]] - j, new);
> +			stmpe_reg_write(stmpe, stmpe->regs[regmap[i][j]], new);
>  		}
>  	}
>  
> @@ -214,9 +222,9 @@ static void stmpe_dbg_show_one(struct seq_file *s,
>  	struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(gc);
>  	struct stmpe *stmpe = stmpe_gpio->stmpe;
>  	const char *label = gpiochip_is_requested(gc, offset);
> -	int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8);
>  	bool val = !!stmpe_gpio_get(gc, offset);
> -	u8 dir_reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8);
> +	u8 bank = offset / 8;
> +	u8 dir_reg = stmpe->regs[STMPE_IDX_GPDR_LSB + bank];
>  	u8 mask = 1 << (offset % 8);
>  	int ret;
>  	u8 dir;
> @@ -257,18 +265,16 @@ static void stmpe_dbg_show_one(struct seq_file *s,
>  		case STMPE1601:
>  		case STMPE2401:
>  		case STMPE2403:
> -			edge_det_reg = stmpe->regs[STMPE_IDX_GPEDR_MSB] +
> -				       num_banks - 1 - (offset / 8);
> +			edge_det_reg = stmpe->regs[STMPE_IDX_GPEDR_LSB + bank];
>  			ret = stmpe_reg_read(stmpe, edge_det_reg);
>  			if (ret < 0)
>  				return;
>  			edge_det = !!(ret & mask);
>  
>  		case STMPE1801:
> -			rise_reg = stmpe->regs[STMPE_IDX_GPRER_LSB] -
> -				   (offset / 8);
> -			fall_reg = stmpe->regs[STMPE_IDX_GPFER_LSB] -
> -				   (offset / 8);
> +			rise_reg = stmpe->regs[STMPE_IDX_GPRER_LSB + bank];
> +			fall_reg = stmpe->regs[STMPE_IDX_GPFER_LSB + bank];
> +
>  			ret = stmpe_reg_read(stmpe, rise_reg);
>  			if (ret < 0)
>  				return;
> @@ -279,8 +285,7 @@ static void stmpe_dbg_show_one(struct seq_file *s,
>  			fall = !!(ret & mask);
>  
>  		case STMPE801:
> -			irqen_reg = stmpe->regs[STMPE_IDX_IEGPIOR_LSB] -
> -				    (offset / 8);
> +			irqen_reg = stmpe->regs[STMPE_IDX_IEGPIOR_LSB + bank];
>  			break;
>  
>  		default:
> @@ -362,8 +367,9 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
>  		 */
>  		if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) {
>  			stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
> -			stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB]
> -					+ i, status[i]);
> +			stmpe_reg_write(stmpe,
> +					stmpe->regs[STMPE_IDX_GPEDR_LSB + i],
> +					status[i]);
>  		}
>  	}
>  

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html