Re: [PATCH 6/6] pinctrl: tegra: Add driver to configure voltage and power state of io pads

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Mon, May 2, 2016 at 2:17 PM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote:

> NVIDIA Tegra210 supports the IO pads which can operate at 1.8V
> or 3.3V I/O voltage levels. Also the IO pads can be configured
> for power down state if it is not used. SW needs to configure the
> voltage level of IO pads based on IO rail voltage and its power
> state based on platform usage.
>
> The voltage and power state configurations of pads are provided
> through pin control frameworks. Add pin control driver for Tegra's
> IO pads' voltage and power state configurations.
>
> Signed-off-by: Laxman Dewangan <ldewangan@xxxxxxxxxx>
>
> ---
> Changes from V1:
> - Use the generic pincontrol property for low power enable/disable.
> - sync with latest and remove all MODULE* macros
> - Use renamed APIs form PMC

Looks OK to me, need Stephen's ACK though!

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html