On Fri, Apr 29, 2016 at 11:20 AM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote: > On Friday 29 April 2016 02:37 PM, Linus Walleij wrote: >> On Mon, Apr 25, 2016 at 12:38 PM, Laxman Dewangan <ldewangan@xxxxxxxxxx> >> wrote: >> >>> Add support for the debounce as Tegra210 support debounce in HW. >>> Also do the clenaups to remove all global variables. >> >> OK this v5 is applied. >> >> Laxman does this GPIO also have open drain and/or open source >> handling? > > > Some of the pins support the open drain and these are part of pinmux > register set. > For that we have property for setting open drain. > > Is it possible to link the gpio APIs to pincontrol for setting that pin? I have the same issue with Nomadik pin control that I use as a testbed: there is a backend in pin control to the GPIO side. I was thinking about adding a new cross call. We now have this: /* External interface to pin control */ extern int pinctrl_request_gpio(unsigned gpio); extern void pinctrl_free_gpio(unsigned gpio); extern int pinctrl_gpio_direction_input(unsigned gpio); extern int pinctrl_gpio_direction_output(unsigned gpio); I was going to add: extern int pinctrl_gpio_set_config(unsigned gpio, unsigned long config); That can be used by GPIO drivers to call back into pincontrol and set up any config flags using the conventions of the corresponding pin control back-end. This could be used for as well open drain as other things (like pull-up) as the userspace ABI matures (it currently only has in/out and open drain/source). What do you think about this idea? >> Then you might want to look into supporting that too as I just added >> support for native single-endedness to gpiolib, c.f.: >> http://marc.info/?l=linux-gpio&m=146011780301280&w=2 > > Yaah, Some of PMIC's (which I am handling) gpios support open drain and I > think I can have changes for the PMIC gpio driver. Nice! :) >> It would be nice if you also implement .get_direction() which >> makes debugfs and initial reading of the state of the lines >> more accurate. > > Sure, this can be implemented. > Will post the patch on top of the series soon. Thanks. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html