Re: [PATCH 6/7] pinctrl: tegra: Add DT binding for io pads control

[Jon Hunter <jonathanh@xxxxxxxxxx>]

On 15/04/16 17:41, Laxman Dewangan wrote:
> 
> On Friday 15 April 2016 09:15 PM, Jon Hunter wrote:
>> On 15/04/16 16:14, Laxman Dewangan wrote:
>>>
>>> I used pins as this is the property from pincon generic so that I can
>>> use the generic implementation.
>>>
>>> Here, I will not go to the pin level control as HW does not support pin
>>> level control.
>>>
>>> I will say the unit should be interface level. Should we say
>>> IO_GROUP_CSIA, IO_GROUP_CSIB etc?
>> So we need to reflect the hardware in device-tree and although yes the
>> power-down for the CSI_x_xxx pads are all controlled together as a
>> single group, it does not feel right that we add a pseudo pin called
>> csix to represent these.
>>
>> The CSI_x_xxx pads are already in device-tree and so why not add a
>> property to each of these pads which has the IO rail information for
>> power-down and voltage-select?
> 
> Which dt binding docs have these?
> I looked for nvidia,tegra210-pinmux.txt and not able to find csi_xxx.

For CSI you are right they are not included by the current DT binding
docs, however, the sdmmc1/3 pads are. So that makes things a bit more
messy as some are and some are not.

> Here I dont want to refer the individual pins as control should be as
> group.

I understand, however, at least for power-down control I don't see why
we cannot refer to the individual pins and once all are inactive then
the rail can be powered down.

For switching the voltage it is a bit more complex, but may be we could
still look-up the IO rail based upon the pads the device uses.

Cheers
Jon


--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html