Re: [PATCH 7/7] pinctrl: tegra: Add driver to configure voltage and power state of io pads

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Fri, Apr 15, 2016 at 1:47 PM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote:
> On Friday 15 April 2016 04:45 PM, Linus Walleij wrote:
>> On Fri, Apr 15, 2016 at 11:55 AM, Laxman Dewangan <ldewangan@xxxxxxxxxx>
>> wrote:

>> But to be sure we would like to know what is actually happening,
>> electronically speaking, when you set this up. Do you have any
>> idea?
>
> From electronic point of view, the value of VIL, VIH, VOL, VOH (Input/output
> voltage level for low and high state) are different when talking for 0 t
> 1.8V and 0 to 3.3V.

Yeah that I get. But since it is switched on a per-pin basis, and
this is not about what voltage is actually supplied to the I/O cell,
because that comes from the outside, it is a mystery why it is
even needed.

I understand that there is a bit selecting driving voltage level in
the register range, what I don't understand is what that is
doing in the I/O cell.

The bit in the register must be routed to somehing in the I/O cell
and I would like to know what. I take it that an ordinary CMOS
totem-pole push-pull output is going to work the same with 1.8
and 3.3V alike so it's obviously not enabling any extra transistors
or anything.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html