This patch series is extension of my original single patch with the same subject. It adds support for R_PIO so that GPIO port L can be used in H3 based devices. It was tested on OrangePi PC where PL is connected amount others to an onboard led, a switch, an IR receiver and some VCC controllers. Patchset is based on next-20160129. --- Changes since v2: - fixed apb0 parrent clocks list - moved binding documentation change to the proper patch - simplified sunxi_pinctrl_gpio_get according to ChenYu suggestions - fixed ordering in sunxi binding documentation Changes since v1: - splited patch to two separate - dtsi and c files - added APB0 clocks a parent for R_PIO - added fix in sunxi_pinctrl_gpio_get for getting pin value when in irq mode and on 2nd pinctrl - fixed a "pwn" > "pwm" typo - fixed order in allwinner,sunxi-pinctrl.txt Krzysztof Adamski (5): clk: sunxi: Add apb0 gates for H3 dts: sun8i-h3: Add APB0 related clocks and resets pinctrl: sunxi: Add H3 R_PIO controller support ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi pinctrl: sunxi: Use pin number when calling sunxi_pmx_set Documentation/devicetree/bindings/clock/sunxi.txt | 1 + .../bindings/pinctrl/allwinner,sunxi-pinctrl.txt | 1 + arch/arm/boot/dts/sun8i-h3.dtsi | 36 +++++++ drivers/clk/sunxi/clk-simple-gates.c | 2 + drivers/pinctrl/sunxi/Kconfig | 4 + drivers/pinctrl/sunxi/Makefile | 1 + drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c | 106 +++++++++++++++++++++ drivers/pinctrl/sunxi/pinctrl-sunxi.c | 5 +- 8 files changed, 154 insertions(+), 2 deletions(-) create mode 100644 drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html