On 21.02.2025 21:32, Artur Weber wrote:
Add device tree bindings for the pin controller included in the
BCM21664 chip. The bindings are based off brcm,bcm11351-pinctrl.yaml;
both chips use the same driver, but have different pins, and the
BCM21664 has 6 alt modes instead of 4.
Signed-off-by: Artur Weber <aweber.kernel@xxxxxxxxx>
---
(...)
+examples:
+ - |
+ pinctrl@35004800 {
+ compatible = "brcm,bcm21664-pinctrl";
+ reg = <0x35004800 0x7f0>;
+
+ dev-a-active-pins {
+ /* group node defining 1 standard pin */
+ std-grp0 {
+ pins = "gpio00";
+ function = "alt1";
+ input-schmitt-enable;
+ bias-disable;
+ slew-rate = <1>;
+ drive-strength = <4>;
+ };
+
+ /* group node defining 2 I2C pins */
+ i2c-grp0 {
+ pins = "bsc1clk", "bsc1dat";
+ function = "alt2";
+ bias-pull-up = <720>;
+ input-enable;
bias-pull-up should not have a value (pull up strength is not
supported). Will fix this in the next version.
+ };
+ };
+ };
+...
Best regards
Artur
