[PATCH v1 1/2] pwm: lpss: Clarify the bypass member semantics in struct pwm_lpss_boardinfo

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

Instead of an odd comment, cite the documentation, which says more clearly
what's going on with the programming flow on some of the Intel SoCs.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
 include/linux/platform_data/x86/pwm-lpss.h | 33 ++++++++++++++++++++--
 1 file changed, 30 insertions(+), 3 deletions(-)

diff --git a/include/linux/platform_data/x86/pwm-lpss.h b/include/linux/platform_data/x86/pwm-lpss.h
index 752c06b47cc8..f0349edb47f4 100644
--- a/include/linux/platform_data/x86/pwm-lpss.h
+++ b/include/linux/platform_data/x86/pwm-lpss.h
@@ -15,9 +15,36 @@ struct pwm_lpss_boardinfo {
 	unsigned int npwm;
 	unsigned long base_unit_bits;
 	/*
-	 * Some versions of the IP may stuck in the state machine if enable
-	 * bit is not set, and hence update bit will show busy status till
-	 * the reset. For the rest it may be otherwise.
+	 * NOTE:
+	 * Intel Broxton, Apollo Lake, and Gemini Lake have different programming flow.
+	 *
+	 * Initial Enable or First Activation
+	 * 1. Program the base unit and on time divisor values.
+	 * 2. Set the software update bit.
+	 * 3. Poll in a loop on the PWMCTRL bit until software update bit is cleared.+
+	 * 4. Enable the PWM output by setting PWM Enable.
+	 * 5. Repeat the above steps for the next PWM Module.
+	 *
+	 * Dynamic update while PWM is Enabled
+	 * 1. Program the base unit and on-time divisor values.
+	 * 2. Set the software update bit.
+	 * 3. Repeat the above steps for the next PWM module.
+	 *
+	 * + After setting PWMCTRL register's SW update bit, hardware automatically
+	 * deasserts the SW update bit after a brief delay. It was observed that
+	 * setting of PWM enable is typically done via read-modify-write of the PWMCTRL
+	 * register. If there is no/little delay between setting software update bit
+	 * and setting enable bit via read-modify-write, it is possible that the read
+	 * could return with software enable as 1. In that case, the last write to set
+	 * enable to 1 could also set sw_update to 1. If this happens, sw_update gets
+	 * stuck and the driver code can hang as it explicitly waits for sw_update bit
+	 * to be 0 after setting the enable bit to 1. To avoid this race condition,
+	 * SW should poll on the software update bit to make sure that it is 0 before
+	 * doing the read-modify-write to set the enable bit to 1.
+	 *
+	 * Also, we noted that if sw_update bit was set in step #1 above then when it
+	 * is set again in step #2, sw_update bit never gets cleared and the flow hangs.
+	 * As such, we need to make sure that sw_update bit is 0 when doing step #1.
 	 */
 	bool bypass;
 	/*
-- 
2.45.1.3035.g276e886db78b