Add check for the return value of clk_enable() to catch the potential error. Change return type of nmk_gpio_glitch_slpm_init casade. Fixes: 3a19805920f1 ("pinctrl: nomadik: move all Nomadik drivers to subdir") Signed-off-by: Mingwei Zheng <zmw12306@xxxxxxxxx> Signed-off-by: Jiasheng Jiang <jiashengjiangcool@xxxxxxxxx> --- drivers/pinctrl/nomadik/pinctrl-nomadik.c | 29 +++++++++++++++++------ 1 file changed, 22 insertions(+), 7 deletions(-) diff --git a/drivers/pinctrl/nomadik/pinctrl-nomadik.c b/drivers/pinctrl/nomadik/pinctrl-nomadik.c index f4f10c60c1d2..2207c9513afd 100644 --- a/drivers/pinctrl/nomadik/pinctrl-nomadik.c +++ b/drivers/pinctrl/nomadik/pinctrl-nomadik.c @@ -438,9 +438,9 @@ static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct, * - Any spurious wake up event during switch sequence to be ignored and * cleared */ -static void nmk_gpio_glitch_slpm_init(unsigned int *slpm) +static int nmk_gpio_glitch_slpm_init(unsigned int *slpm) { - int i; + int i, ret; for (i = 0; i < NMK_MAX_BANKS; i++) { struct nmk_gpio_chip *chip = nmk_gpio_chips[i]; @@ -449,11 +449,15 @@ static void nmk_gpio_glitch_slpm_init(unsigned int *slpm) if (!chip) break; - clk_enable(chip->clk); + ret = clk_enable(chip->clk); + if (ret) + return ret; slpm[i] = readl(chip->addr + NMK_GPIO_SLPC); writel(temp, chip->addr + NMK_GPIO_SLPC); } + + return 0; } static void nmk_gpio_glitch_slpm_restore(unsigned int *slpm) @@ -923,7 +927,9 @@ static int nmk_pmx_set(struct pinctrl_dev *pctldev, unsigned int function, slpm[nmk_chip->bank] &= ~BIT(bit); } - nmk_gpio_glitch_slpm_init(slpm); + ret = nmk_gpio_glitch_slpm_init(slpm); + if (ret) + goto out_pre_slpm_init; } for (i = 0; i < g->grp.npins; i++) { @@ -940,7 +946,10 @@ static int nmk_pmx_set(struct pinctrl_dev *pctldev, unsigned int function, dev_dbg(npct->dev, "setting pin %d to altsetting %d\n", g->grp.pins[i], g->altsetting); - clk_enable(nmk_chip->clk); + ret = clk_enable(nmk_chip->clk); + if (ret) + goto out_glitch; + /* * If the pin is switching to altfunc, and there was an * interrupt installed on it which has been lazy disabled, @@ -988,6 +997,7 @@ static int nmk_gpio_request_enable(struct pinctrl_dev *pctldev, struct nmk_gpio_chip *nmk_chip; struct gpio_chip *chip; unsigned int bit; + int ret; if (!range) { dev_err(npct->dev, "invalid range\n"); @@ -1004,7 +1014,9 @@ static int nmk_gpio_request_enable(struct pinctrl_dev *pctldev, find_nmk_gpio_from_pin(pin, &bit); - clk_enable(nmk_chip->clk); + ret = clk_enable(nmk_chip->clk); + if (ret) + return ret; /* There is no glitch when converting any pin to GPIO */ __nmk_gpio_set_mode(nmk_chip, bit, NMK_GPIO_ALT_GPIO); clk_disable(nmk_chip->clk); @@ -1058,6 +1070,7 @@ static int nmk_pin_config_set(struct pinctrl_dev *pctldev, unsigned int pin, unsigned long cfg; int pull, slpm, output, val, i; bool lowemi, gpiomode, sleep; + int ret; nmk_chip = find_nmk_gpio_from_pin(pin, &bit); if (!nmk_chip) { @@ -1116,7 +1129,9 @@ static int nmk_pin_config_set(struct pinctrl_dev *pctldev, unsigned int pin, output ? (val ? "high" : "low") : "", lowemi ? "on" : "off"); - clk_enable(nmk_chip->clk); + ret = clk_enable(nmk_chip->clk); + if (ret) + return ret; if (gpiomode) /* No glitch when going to GPIO mode */ __nmk_gpio_set_mode(nmk_chip, bit, NMK_GPIO_ALT_GPIO); -- 2.34.1