Re: [PATCH v3 02/12] dt-bindings: pinctrl: Add RaspberryPi RP1 gpio/pinctrl/pinmux bindings

[Krzysztof Kozlowski <krzk@xxxxxxxxxx>]

On 04/11/2024 12:11, Andrea della Porta wrote:

>>>>
>>>> Your example does not use any subnodes, so this looks not needed.
>>>
>>> The example has subnodes, as in the following excerpt from the example:
>>
>> I meant, you do not need properties in subnodes (1st level). You only
>> want properties in subnodes of subnodes, so 2nd level. What is the point
>> of allowing them in 1st level?
> 
> I will add those two sub-nodes to the example:
> 
>             rp1-i2s0-default-state {
>                 function = "i2s0";
>                 pins = "gpio18", "gpio19", "gpio20", "gpio21";
>                 bias-disable;
>             };
> 
>             rp1-uart0-default-state {
>                 txd-pins {
>                     function = "uart0";
>                     pins = "gpio14";
>                     bias-disable;
>                 };
> 
>                 rxd-pins {
>                     function = "uart0";
>                     pins = "gpio15";
>                     bias-pull-up;
>                 };
>             };
> 
> The first is just a group of pins with the same settings, the second is 
> a pin group with different settings per pin. This is basically the same
> usage as in qcom,sm4250-lpass-lpi-pinctrl.yaml.
> 

Ack, that's ok then.

Best regards,
Krzysztof