Re: [PATCH v3 6/6] gpiolib: notify user-space about in-kernel line state changes

[Bartosz Golaszewski <brgl@xxxxxxxx>]

On Wed, Oct 16, 2024 at 11:17 AM Kent Gibson <warthog618@xxxxxxxxx> wrote:
>
> >
> > Does the following help?
> >
> > @@ -2830,7 +2860,7 @@ int gpiod_direction_output(struct gpio_desc
> > *desc, int value)
> >                       goto set_output_value;
> >               /* Emulate open drain by not actively driving the line high */
> >               if (value) {
> > -                     ret = gpiod_direction_input(desc);
> > +                     ret = gpiod_direction_input_nonotify(desc);
> >                       goto set_output_flag;
> >               }
> >       } else if (test_bit(FLAG_OPEN_SOURCE, &flags)) {
> > @@ -2839,7 +2869,7 @@ int gpiod_direction_output(struct gpio_desc
> > *desc, int value)
> >                       goto set_output_value;
> >               /* Emulate open source by not actively driving the line low */
> >               if (!value) {
> > -                     ret = gpiod_direction_input(desc);
> > +                     ret = gpiod_direction_input_nonotify(desc);
> >                       goto set_output_flag;
> >               }
> >       } else {
> >
>
> That fixes the drive problems.
>

Ok, thanks.

> > >> Still haven't tested any debounce changes...
> > >>
> > >
> > > Have now.
> > >
> > > input -> input|debounce
> > >
> > > does not report the debounce.  Only get the one event and it does not
> > > contain any debounce.
> > >
> >
> > You mean, you get a CHANGED_CONFIG event but the debounce value is not
> > in the associated line info?
> >
>
> Correct.
>

Ok, let me see.

Bart