On Wed, Dec 09, 2015 at 02:12:40PM +0100, Linus Walleij wrote: ... > @@ -55,16 +54,16 @@ static int moxart_gpio_probe(struct platform_device *pdev) > return ret; > } > > - bgc->gc.label = "moxart-gpio"; > - bgc->gc.request = gpiochip_generic_request; > - bgc->gc.free = gpiochip_generic_free; > - bgc->data = bgc->read_reg(bgc->reg_set); > - bgc->gc.base = 0; > - bgc->gc.ngpio = 32; > - bgc->gc.parent = dev; > - bgc->gc.owner = THIS_MODULE; > + gc->label = "moxart-gpio"; > + gc->request = gpiochip_generic_request; > + gc->free = gpiochip_generic_free; > + gc->bgpio_data = bgc->read_reg(bgc->reg_set); > + gc->base = 0; > + gc->ngpio = 32; > + gc->parent = dev; > + gc->owner = THIS_MODULE; > > - ret = gpiochip_add(&bgc->gc); > + ret = gpiochip_add_data(gc, NULL); > if (ret) { gpiochip_add is still mentioned in the dev_err below. > dev_err(dev, "%s: gpiochip_add failed\n", > dev->of_node->full_name); ... > @@ -226,14 +225,14 @@ static int sdv_gpio_probe(struct pci_dev *pdev, > writel(mux_val, sd->gpio_pub_base + GPMUXCTL); > } > > - ret = bgpio_init(&sd->bgpio, &pdev->dev, 4, > + ret = bgpio_init(&sd->chip, &pdev->dev, 4, > sd->gpio_pub_base + GPINR, sd->gpio_pub_base + GPOUTR, > NULL, sd->gpio_pub_base + GPOER, NULL, 0); > if (ret) > goto unmap; > - sd->bgpio.gc.ngpio = SDV_NUM_PUB_GPIOS; > + sd->chip.ngpio = SDV_NUM_PUB_GPIOS; > > - ret = gpiochip_add(&sd->bgpio.gc); > + ret = gpiochip_add_data(&sd->chip, sd); > if (ret < 0) { Also still mentioned here in the dev_err. > dev_err(&pdev->dev, "gpiochip_add() failed.\n"); > goto unmap; ... > @@ -201,8 +201,8 @@ static int vexpress_sysreg_probe(struct platform_device *pdev) > return -ENOMEM; > bgpio_init(mmc_gpio_chip, &pdev->dev, 0x4, base + SYS_MCI, > NULL, NULL, NULL, NULL, 0); Was going to complain about this one not switching to _data but it was addressed in a follow up patch. > - mmc_gpio_chip->gc.ngpio = 2; > - gpiochip_add(&mmc_gpio_chip->gc); > + mmc_gpio_chip->ngpio = 2; > + gpiochip_add(mmc_gpio_chip); -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html