[PATCH v4 4/5] pinctrl: qcom: ipq5018: allow it to be bulid on arm32

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



There are some ipq5018 based device's firmware only can able to boot
arm32 but the pinctrl driver dont allow it to be compiled on
arm32.Therefore this patch needed for those devices.

Signed-off-by: Karl Chan <exxxxkc@xxxxxxxxxxxxxxx>
---
 drivers/pinctrl/qcom/Kconfig.msm | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pinctrl/qcom/Kconfig.msm b/drivers/pinctrl/qcom/Kconfig.msm
index 8fe459d082ed..65cec6c50994 100644
--- a/drivers/pinctrl/qcom/Kconfig.msm
+++ b/drivers/pinctrl/qcom/Kconfig.msm
@@ -24,7 +24,7 @@ config PINCTRL_IPQ4019
 
 config PINCTRL_IPQ5018
 	tristate "Qualcomm Technologies, Inc. IPQ5018 pin controller driver"
-	depends on ARM64 || COMPILE_TEST
+	depends on ARM || ARM64 || COMPILE_TEST
 	help
 	  This is the pinctrl, pinmux, pinconf and gpiolib driver for
 	  the Qualcomm Technologies Inc. TLMM block found on the
-- 
2.46.1





[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux