Re: [PATCH v4 6/6] gpio: aspeed: Add the flush write to ensure the write complete.

[Bartosz Golaszewski <brgl@xxxxxxxx>]

On Tue, Oct 1, 2024 at 4:18 PM Linus Walleij <linus.walleij@xxxxxxxxxx> wrote:
>
> On Thu, Sep 19, 2024 at 11:43 AM Billy Tsai <billy_tsai@xxxxxxxxxxxxxx> wrote:
>
> > Performing a dummy read ensures that the register write operation is fully
> > completed, mitigating any potential bus delays that could otherwise impact
> > the frequency of bitbang usage. E.g., if the JTAG application uses GPIO to
> > control the JTAG pins (TCK, TMS, TDI, TDO, and TRST), and the application
> > sets the TCK clock to 1 MHz, the GPIO’s high/low transitions will rely on
> > a delay function to ensure the clock frequency does not exceed 1 MHz.
> > However, this can lead to rapid toggling of the GPIO because the write
> > operation is POSTed and does not wait for a bus acknowledgment.
> >
> > Signed-off-by: Billy Tsai <billy_tsai@xxxxxxxxxxxxxx>
>
> If this applies cleanly on mainline I think it should go into fixes as-is.
>
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
>
> Yours,
> Linus Walleij

I agree but it doesn't. :(

Billy: please send it separately and - while at it - use a C-style comment.

Bart