Re: [PATCH v3 00/10] Add minimal Exynos8895 SoC and SM-G950F support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 9/3/24 17:45, Krzysztof Kozlowski wrote:
> On 03/09/2024 14:44, Ivaylo Ivanov wrote:
>> Hi folks,
>>
>> This series adds initial SoC support for the Exynos 8895 SoC and also
>> initial board support for Samsung Galaxy S8 phone (SM-G950F), codenamed
>> dreamlte.
>>
>> The Exynos 8895 SoC is also used in S8 Plus (dream2lte), Note 8 (greatlte)
>> and Meizu 15 Plus (m1891). Currently DT is added for the Exynos 8895 SoC
>> and dreamlte, but it should be really easy to adapt for the other devices
>> with the same SoC.
> How did you resolve this comment:
>
> "I do not believe this was tested. See maintainer SoC profile for
> Samsung Exynos."
>
> ?
> - Fixed suffixes for the exynos8895 pinctrl device tree

It seems, however, that I've left a few nodes improper.


$ make CHECK_DTBS=y ARCH=arm64 CROSS_COMPILE=aarch64-linux-gnu- exynos/exynos8895-dreamlte.dtb W=1
  DTC_CHK arch/arm64/boot/dts/exynos/exynos8895-dreamlte.dtb
arch/arm64/boot/dts/exynos/exynos8895.dtsi:175.38-186.5: Warning (simple_bus_reg): /soc@0/interrupt-controller@10200000: simple-bus unit address format error, expected "10201000"
/home/ivaylo/linux/s8/for-upstream/linux/arch/arm64/boot/dts/exynos/exynos8895-dreamlte.dtb: pinctrl@11430000: 'sd2-clk_fast_slew_rate_1x-pins', 'sd2-clk_fast_slew_rate_2x-pins', 'sd2-clk_fast_slew_rate_3x-pins', 'sd2-clk_fast_slew_rate_4x-pins' do not match any of the regexes: '^(initial|sleep)-state$', '^[a-z0-9-]+-pins$', '^[a-z]+[0-9]*-gpio-bank$', 'pinctrl-[0-9]+'
    from schema $id: http://devicetree.org/schemas/pinctrl/samsung,pinctrl.yaml#
/home/ivaylo/linux/s8/for-upstream/linux/arch/arm64/boot/dts/exynos/exynos8895-dreamlte.dtb: pinctrl@164b0000: gpa1-gpio-bank:#interrupt-cells:0:0: 2 was expected
    from schema $id: http://devicetree.org/schemas/pinctrl/samsung,pinctrl.yaml#
/home/ivaylo/linux/s8/for-upstream/linux/arch/arm64/boot/dts/exynos/exynos8895-dreamlte.dtb: pinctrl@164b0000: 'key-power', 'key-voldown', 'key-volup', 'key-wink', 'pcie_wake-pins', 'wlan_host_wake-pins' do not match any of the regexes: '^(initial|sleep)-state$', '^[a-z0-9-]+-pins$', '^[a-z]+[0-9]*-gpio-bank$', 'pinctrl-[0-9]+'
    from schema $id: http://devicetree.org/schemas/pinctrl/samsung,pinctrl.yaml#


I'll ensure this is properly tested and fixed next time.


Thanks for the quick response and best regards,

Ivaylo





[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux