On 8/20/24 07:36, Andrea della Porta wrote:
RaspberryPi RP1 is multi function PCI endpoint device that exposes several subperipherals via PCI BAR. Add an ethernet node for Cadence MACB to the RP1 dtso Signed-off-by: Andrea della Porta <andrea.porta@xxxxxxxx> --- arch/arm64/boot/dts/broadcom/rp1.dtso | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) diff --git a/arch/arm64/boot/dts/broadcom/rp1.dtso b/arch/arm64/boot/dts/broadcom/rp1.dtso index d80178a278ee..b40e203c28d5 100644 --- a/arch/arm64/boot/dts/broadcom/rp1.dtso +++ b/arch/arm64/boot/dts/broadcom/rp1.dtso @@ -78,6 +78,29 @@ rp1_clocks: clocks@c040018000 { <50000000>; // RP1_CLK_ETH_TSU };+ rp1_eth: ethernet@c040100000 {+ reg = <0xc0 0x40100000 0x0 0x4000>; + compatible = "cdns,macb"; + #address-cells = <1>; + #size-cells = <0>; + interrupts = <RP1_INT_ETH IRQ_TYPE_LEVEL_HIGH>; + clocks = <&macb_pclk &macb_hclk &rp1_clocks RP1_CLK_ETH_TSU>; + clock-names = "pclk", "hclk", "tsu_clk"; + phy-mode = "rgmii-id"; + cdns,aw2w-max-pipe = /bits/ 8 <8>; + cdns,ar2r-max-pipe = /bits/ 8 <8>; + cdns,use-aw2b-fill; + local-mac-address = [00 00 00 00 00 00]; + phy-handle = <&phy1>; + phy-reset-gpios = <&rp1_gpio 32 GPIO_ACTIVE_LOW>; + phy-reset-duration = <5>; + + phy1: ethernet-phy@1 { + reg = <0x1>; + brcm,powerdown-enable;
Undocumented property, and I would like to understand why this needs to be specified in the Device Tree? What model of Broadcom Ethernet PHY is being used here?
-- Florian
