Re: [PATCH] gpio: Add GPIO support for the ACCES 104-IDI-48

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Mon, Nov 23, 2015 at 6:54 PM, William Breathitt Gray
<vilhelm.gray@xxxxxxxxx> wrote:

> The ACCES 104-IDI-48 family of PC/104 utility boards feature 48
> individually optically isolated digital inputs. Enabled inputs feature
> change-of-state detection capability; if change-of-state detection is
> enabled, an interrupt is fired off if a change of input level
> (low-to-high or high-to-low) is detected. Change-of-state IRQs are
> enabled/disabled on 8-bit boundaries, for a total of six boundaries.
>
> This driver provides GPIO and IRQ support for these 48 channels of
> digital input. The base port address for the device may be configured
> via the idi_48_base module parameter. The interrupt line number for the
> device may be configured via the idi_48_irq module parameter.
>
> Signed-off-by: William Breathitt Gray <vilhelm.gray@xxxxxxxxx>

This is a very nice and clean written driver.

Patch applied.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html