Re: [PATCH 1/2] ls2080a/dts: Add little endian property for GPIO IP block

[Li Yang <leoli@xxxxxxxxxxxxx>]

On Mon, Nov 16, 2015 at 9:11 AM, Linus Walleij <linus.walleij@xxxxxxxxxx> wrote:
> On Tue, Nov 3, 2015 at 12:19 PM, Liu Gang <Gang.Liu@xxxxxxxxxxxxx> wrote:
>
>> The GPIO block for ls2080a platform has little endian registers,
>> the GPIO driver needs this property to read/write registers by
>> right interface.
>>
>> Signed-off-by: Liu Gang <Gang.Liu@xxxxxxxxxxxxx>
>>
>> diff --git a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
>> index f2455c5..c836dab 100644
>> --- a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
>> +++ b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
>> @@ -10,6 +10,9 @@ Required properties:
>>    the second cell is used to specify the gpio polarity:
>>        0 = active high
>>        1 = active low
>> +- little-endian : Should be set if the GPIO has little endian
>> +                 registers. No the property means the GPIO
>> +                 registers are big endian mode.
>
> That is a very generic binding and I would like the devicetree
> maintainers to say something about this.
>
> I would be OK if this is specified for *all* gpiochips in
> Documentation/devicetree/bindings/gpio/gpio.txt
> or even higher up in the desriptions.
>
> Just for Freescale seems a bit too local.

There is already a generic definition at
Documentation/devicetree/bindings/common-properties.txt.  But it will
be special for Freescale controller to say that the default is
big-endian for backward compatibility.

Regards,
Leo
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html