The GPIO block for ls2080a platform has little endian registers, the GPIO driver needs this property to read/write registers by right interface. Signed-off-by: Liu Gang <Gang.Liu@xxxxxxxxxxxxx> --- V2 changes: No Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt | 3 +++ arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi | 4 ++++ 2 files changed, 7 insertions(+) diff --git a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt index f2455c5..c836dab 100644 --- a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt +++ b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt @@ -10,6 +10,9 @@ Required properties: the second cell is used to specify the gpio polarity: 0 = active high 1 = active low +- little-endian : Should be set if the GPIO has little endian + registers. No the property means the GPIO + registers are big endian mode. Example: diff --git a/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi index e81cd48..0099205 100644 --- a/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi +++ b/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi @@ -277,6 +277,7 @@ reg = <0x0 0x2300000 0x0 0x10000>; interrupts = <0 36 0x4>; /* Level high type */ gpio-controller; + little-endian; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; @@ -287,6 +288,7 @@ reg = <0x0 0x2310000 0x0 0x10000>; interrupts = <0 36 0x4>; /* Level high type */ gpio-controller; + little-endian; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; @@ -297,6 +299,7 @@ reg = <0x0 0x2320000 0x0 0x10000>; interrupts = <0 37 0x4>; /* Level high type */ gpio-controller; + little-endian; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; @@ -307,6 +310,7 @@ reg = <0x0 0x2330000 0x0 0x10000>; interrupts = <0 37 0x4>; /* Level high type */ gpio-controller; + little-endian; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; -- 2.1.0.27.g96db324 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html