On Wed, 2015-09-02 at 14:02 +0800, Daniel Kurtz wrote: > Hi maoguang, > > On Tue, Aug 25, 2015 at 12:27 AM, Sudeep Holla <sudeep.holla@xxxxxxx> wrote: > > > > > > On 14/08/15 09:38, maoguang.meng@xxxxxxxxxxxx wrote: > >> > >> From: Maoguang Meng <maoguang.meng@xxxxxxxxxxxx> > >> > >> This patch implement irq_set_wake to get who is wakeup source and > >> setup on suspend resume. > >> > >> Signed-off-by: Maoguang Meng <maoguang.meng@xxxxxxxxxxxx> > >> > [snip] > > Can you please respond to Sudeep's questions: > > > Does this pinmux controller: > > > > 1. Support wake-up configuration ? If not, you need to use > > IRQCHIP_SKIP_SET_WAKE. I don't see any value in writing the > > mask_{set,clear} if the same registers are used for {en,dis}able YES. we can call enable_irq_wake(irq) to config this irq as a wake-up source. > > > > 2. Is in always on domain ? If not, you need save/restore only to > > resume back the functionality. Generally we can set > > IRQCHIP_MASK_ON_SUSPEND to ensure non-wake-up interrupts are > > disabled during suspend and re-enabled in resume path. You just > > save/restore raw values without tracking the wake-up source. YES. > > > > Also I see that no care is taken to set the port irq as wake enable > > source. It may work with current mainline, but won't with -next. Please > > ensure the port irq to the parent interrupt controller remains > > enabled(i.e set as wake). As you know, we do not care the port irq as wake enbale source, when enter suspend we think no matter what the port irq is enabled/disabled which are not affected as a wake-up source, Because eint has a line to receive SPM. For example,after suspend,press power key(use eint5) will generate an electrical signal which is send to spm by eint. and then spm wake cpu. > > > > Regards, > > Sudeep Regards, Maoguang -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html