Add a set_multiple function to the MPC8xxx GPIO chip driver and thereby allow for actual performance improvements when setting multiple outputs simultaneously. In my case the time needed to configure an FPGA goes down from 48 s to 20 s. Signed-off-by: Rojhalat Ibrahim <imr@xxxxxxxxxxx> Reviewed-by: Alexandre Courbot <acourbot@xxxxxxxxxx> --- This patch depends on my previous patch "gpiolib: allow simultaneous setting of multiple GPIO outputs". Change log: v6: - rebase on current linux-gpio devel branch v5: - no change v4: - change interface of the set_multiple driver function to use unsigned long as type for the bit fields - use generic bitops (which also use unsigned long for bit fields) v3: - change commit message v2: - add this patch (v1 included only changes to gpiolib) drivers/gpio/gpio-mpc8xxx.c | 27 +++++++++++++++++++++++++++ 1 file changed, 27 insertions(+) diff --git a/drivers/gpio/gpio-mpc8xxx.c b/drivers/gpio/gpio-mpc8xxx.c index d7d6d72..d1ff879 100644 --- a/drivers/gpio/gpio-mpc8xxx.c +++ b/drivers/gpio/gpio-mpc8xxx.c @@ -105,6 +105,32 @@ static void mpc8xxx_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val) spin_unlock_irqrestore(&mpc8xxx_gc->lock, flags); } +static void mpc8xxx_gpio_set_multiple(struct gpio_chip *gc, + unsigned long *mask, unsigned long *bits) +{ + struct of_mm_gpio_chip *mm = to_of_mm_gpio_chip(gc); + struct mpc8xxx_gpio_chip *mpc8xxx_gc = to_mpc8xxx_gpio_chip(mm); + unsigned long flags; + int i; + + spin_lock_irqsave(&mpc8xxx_gc->lock, flags); + + for (i = 0; i < gc->ngpio; i++) { + if (*mask == 0) + break; + if (__test_and_clear_bit(i, mask)) { + if (test_bit(i, bits)) + mpc8xxx_gc->data |= mpc8xxx_gpio2mask(i); + else + mpc8xxx_gc->data &= ~mpc8xxx_gpio2mask(i); + } + } + + out_be32(mm->regs + GPIO_DAT, mpc8xxx_gc->data); + + spin_unlock_irqrestore(&mpc8xxx_gc->lock, flags); +} + static int mpc8xxx_gpio_dir_in(struct gpio_chip *gc, unsigned int gpio) { struct of_mm_gpio_chip *mm = to_of_mm_gpio_chip(gc); @@ -344,6 +370,7 @@ static void __init mpc8xxx_add_controller(struct device_node *np) gc->get = of_device_is_compatible(np, "fsl,mpc8572-gpio") ? mpc8572_gpio_get : mpc8xxx_gpio_get; gc->set = mpc8xxx_gpio_set; + gc->set_multiple = mpc8xxx_gpio_set_multiple; gc->to_irq = mpc8xxx_gpio_to_irq; ret = of_mm_gpiochip_add(np, mm_gc); -- 2.0.4 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html