Hello, On 08/24/2010 07:52 PM, Mike Snitzer wrote: >> If it can't be done quickly enough the retry logic can be kept around >> to keep the old behavior but that already was a broken behavior, so... >> :-( > > I'll have to review this thread again to understand why mpath's existing > retry logic is broken behavior. mpath is used with more capable SCSI > devices so I'm missing why a failed FLUSH implies data loss. SBC doesn't specify the failure behavior, so it could be that retrying flush could be safe. But for most disk type devices, flush failure usually indicates that the device exhausted all the options to commit some of pending data to NV media - ie. even remapping failed for whatever reason. Even if retry is safe, it's more likely to simply delay notification of failure. In ATA, the situation is clearer, when a device actively fails a flush, the drive reports the first failed sector it failed to commit and the next flush will continue _after_ the sector - IOW, data is already lost. <speculation> I think there's no reason mpath should be tasked with retrying flush failure. That's upto the SCSI EH. If the command failed in 'safe' transient way - ie. device busy or whatnot, SCSI EH can and does retry the command. There are several FAILFAST bits already and SCSI EH can avoid retrying transport errors for mpath (maybe it already does that?) and just need to be able to tell upper layer that the failure was a fast one and upper layer is responsible for retrying? Is there any reason to pass the whole sense information upwards? </speculation> Anyways, flush failure is different from read/write failures. Read/writes can always be retried cleanly. They are stateless. I don't know how SCSI devices would actually behavior but it's a bit scary to retry SYNCHRONIZE_CACHE a device failed and report success upwards. Thanks. -- tejun -- To unsubscribe from this list: send the line "unsubscribe linux-fsdevel" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html