Re: [PATCH v13 13/35] KVM: Introduce per-page memory attributes

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 11/2/23 04:01, Huang, Kai wrote:
On Fri, 2023-10-27 at 11:21 -0700, Sean Christopherson wrote:
From: Chao Peng <chao.p.peng@xxxxxxxxxxxxxxx>

In confidential computing usages, whether a page is private or shared is
necessary information for KVM to perform operations like page fault
handling, page zapping etc. There are other potential use cases for
per-page memory attributes, e.g. to make memory read-only (or no-exec,
or exec-only, etc.) without having to modify memslots.

Introduce two ioctls (advertised by KVM_CAP_MEMORY_ATTRIBUTES) to allow
userspace to operate on the per-page memory attributes.
   - KVM_SET_MEMORY_ATTRIBUTES to set the per-page memory attributes to
     a guest memory range.
   - KVM_GET_SUPPORTED_MEMORY_ATTRIBUTES to return the KVM supported
     memory attributes.

Use an xarray to store the per-page attributes internally, with a naive,
not fully optimized implementation, i.e. prioritize correctness over
performance for the initial implementation.

Use bit 3 for the PRIVATE attribute so that KVM can use bits 0-2 for RWX
attributes/protections in the future, e.g. to give userspace fine-grained
control over read, write, and execute protections for guest memory.

Provide arch hooks for handling attribute changes before and after common
code sets the new attributes, e.g. x86 will use the "pre" hook to zap all
relevant mappings, and the "post" hook to track whether or not hugepages
can be used to map the range.

To simplify the implementation wrap the entire sequence with
kvm_mmu_invalidate_{begin,end}() even though the operation isn't strictly
guaranteed to be an invalidation.  For the initial use case, x86 *will*
always invalidate memory, and preventing arch code from creating new
mappings while the attributes are in flux makes it much easier to reason
about the correctness of consuming attributes.

It's possible that future usages may not require an invalidation, e.g.
if KVM ends up supporting RWX protections and userspace grants _more_
protections, but again opt for simplicity and punt optimizations to
if/when they are needed.

Suggested-by: Sean Christopherson <seanjc@xxxxxxxxxx>
Link: https://lore.kernel.org/all/Y2WB48kD0J4VGynX@xxxxxxxxxx
Cc: Fuad Tabba <tabba@xxxxxxxxxx>
Cc: Xu Yilun <yilun.xu@xxxxxxxxx>
Cc: Mickaël Salaün <mic@xxxxxxxxxxx>
Signed-off-by: Chao Peng <chao.p.peng@xxxxxxxxxxxxxxx>
Co-developed-by: Sean Christopherson <seanjc@xxxxxxxxxx>
Signed-off-by: Sean Christopherson <seanjc@xxxxxxxxxx>


[...]

+Note, there is no "get" API.  Userspace is responsible for explicitly tracking
+the state of a gfn/page as needed.
+


[...]

+#ifdef CONFIG_KVM_GENERIC_MEMORY_ATTRIBUTES
+static inline unsigned long kvm_get_memory_attributes(struct kvm *kvm, gfn_t gfn)
+{
+	return xa_to_value(xa_load(&kvm->mem_attr_array, gfn));
+}

Only call xa_to_value() when xa_load() returns !NULL?

This xarray does not store a pointer, therefore xa_load() actually returns an integer that is tagged with 1 in the low bit:

static inline unsigned long xa_to_value(const void *entry)
{
        return (unsigned long)entry >> 1;
}

Returning zero for an empty entry is okay, so the result of xa_load() can be used directly.


+
+bool kvm_range_has_memory_attributes(struct kvm *kvm, gfn_t start, gfn_t end,
+				     unsigned long attrs);

Seems it's not immediately clear why this function is needed in this patch,
especially when you said there is no "get" API above.  Add some material to
changelog?

It's used by later patches; even without a "get" API, it's a pretty fundamental functionality.

+bool kvm_arch_pre_set_memory_attributes(struct kvm *kvm,
+					struct kvm_gfn_range *range);
+bool kvm_arch_post_set_memory_attributes(struct kvm *kvm,
+					 struct kvm_gfn_range *range);

Looks if this Kconfig is on, the above two arch hooks won't have implementation.

Is it better to have two __weak empty versions here in this patch?

Anyway, from the changelog it seems it's not mandatory for some ARCH to provide
the above two if one wants to turn this on, i.e., the two hooks can be empty and
the ARCH can just use the __weak version.

I think this can be added by the first arch that needs memory attributes and also doesn't need one of these hooks. Or perhaps the x86 kvm_arch_pre_set_memory_attributes() could be made generic and thus that would be the __weak version. It's too early to tell, so it's better to leave the implementation to the architectures for now.

Paolo





[Index of Archives]     [Linux Ext4 Filesystem]     [Union Filesystem]     [Filesystem Testing]     [Ceph Users]     [Ecryptfs]     [NTFS 3]     [AutoFS]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux Cachefs]     [Reiser Filesystem]     [Linux RAID]     [NTFS 3]     [Samba]     [Device Mapper]     [CEPH Development]

  Powered by Linux