On 12/21/20 10:49 PM, Naohiro Aota wrote:
This is the 1/4 patch to support device-replace in ZONED mode.
We have two types of I/Os during the device-replace process. One is an I/O
to "copy" (by the scrub functions) all the device extents on the source
device to the destination device. The other one is an I/O to "clone" (by
handle_ops_on_dev_replace()) new incoming write I/Os from users to the
source device into the target device.
Cloning incoming I/Os can break the sequential write rule in the target
device. When writing is mapped in the middle of a block group, the I/O is
directed in the middle of a target device zone, which breaks the sequential
write rule.
However, the cloning function cannot be merely disabled since incoming I/Os
targeting already copied device extents must be cloned so that the I/O is
executed on the target device.
We cannot use dev_replace->cursor_{left,right} to determine whether bio is
going to not yet copied region. Since we have a time gap between finishing
btrfs_scrub_dev() and rewriting the mapping tree in
btrfs_dev_replace_finishing(), we can have a newly allocated device extent
which is never cloned nor copied.
So the point is to copy only already existing device extents. This patch
introduces mark_block_group_to_copy() to mark existing block groups as a
target of copying. Then, handle_ops_on_dev_replace() and dev-replace can
check the flag to do their job.
Signed-off-by: Naohiro Aota <naohiro.aota@xxxxxxx>
Reviewed-by: Josef Bacik <josef@xxxxxxxxxxxxxx>
Thanks,
Josef
