On Thu, Nov 5, 2020 at 4:03 PM Jan Kara <jack@xxxxxxx> wrote:
>
> On Wed 04-11-20 19:54:03, Chengguang Xu wrote:
> > ---- 在 星期二, 2020-11-03 01:30:52 Jan Kara <jack@xxxxxxx> 撰写 ----
> > > On Sun 25-10-20 11:41:14, Chengguang Xu wrote:
> > > > Overlayfs cannot be notified when mmapped area gets dirty,
> > > > so we need to proactively mark inode dirty in ->mmap operation.
> > > >
> > > > Signed-off-by: Chengguang Xu <cgxu519@xxxxxxxxxxxx>
> > > > ---
> > > > fs/overlayfs/file.c | 4 ++++
> > > > 1 file changed, 4 insertions(+)
> > > >
> > > > diff --git a/fs/overlayfs/file.c b/fs/overlayfs/file.c
> > > > index efccb7c1f9bc..cd6fcdfd81a9 100644
> > > > --- a/fs/overlayfs/file.c
> > > > +++ b/fs/overlayfs/file.c
> > > > @@ -486,6 +486,10 @@ static int ovl_mmap(struct file *file, struct vm_area_struct *vma)
> > > > /* Drop reference count from new vm_file value */
> > > > fput(realfile);
> > > > } else {
> > > > + if (vma->vm_flags & (VM_SHARED|VM_MAYSHARE) &&
> > > > + vma->vm_flags & (VM_WRITE|VM_MAYWRITE))
> > > > + ovl_mark_inode_dirty(file_inode(file));
> > > > +
> > >
> > > But does this work reliably? I mean once writeback runs, your inode (as
> > > well as upper inode) is cleaned. Then a page fault comes so file has dirty
> > > pages again and would need flushing but overlayfs inode stays clean? Am I
> > > missing something?
> > >
> >
> > Yeah, this is key point of this approach, in order to fix the issue I
> > explicitly set I_DIRTY_SYNC flag in ovl_mark_inode_dirty(), so what i
> > mean is during writeback we will call into ->write_inode() by this
> > flag(I_DIRTY_SYNC) and at that place we get chance to check mapping and
> > re-dirty overlay's inode. The code logic like below in ovl_write_inode().
> >
> > if (mapping_writably_mapped(upper->i_mapping) ||
> > mapping_tagged(upper->i_mapping, PAGECACHE_TAG_WRITEBACK))
> > iflag |= I_DIRTY_PAGES;
>
> OK, but suppose the upper mapping is clean at this moment (upper inode has
> been fully written out for whatever reason, but it is still mapped) so your
> overlayfs inode becomes clean as well. Then I don't see a mechanism which
> would make your overlayfs inode dirty again when a write to mmap happens,
> set_page_dirty() will end up marking upper inode with I_DIRTY_PAGES flag.
>
> Note that ovl_mmap() gets called only at mmap(2) syscall time but then
> pages get faulted in, dirtied, cleaned fully at discretion of the mm
> / writeback subsystem.
>
Perhaps I will add some background.
What I suggested was to maintain a "suspect list" in addition to
the dirty ovl inodes.
ovl inode is added to the suspect list on mmap (writable) and removed
from the suspect list on release() flush() or on sync_fs() if real inode is no
longer writably mapped.
There was another variant where ovl inode is added to suspect list on open
for write and removed from suspect list on release() flush() or sync_fs()
if real inode is not inode_is_open_for_write().
In both cases the list will have inodes whose real is not dirty, but
in both cases
the list shouldn't be terribly large to traverse on sync_fs().
Chengguang tried to implement the idea without an actual list by
re-dirtying the "suspect" inodes on every write_inode(), but I personally have
no idea if his idea works.
I think we can resort to using an actual suspect list if you say that it
cannot work like this?
Thanks,
Amir.
