On 10/30/20 9:51 AM, Naohiro Aota wrote:
Superblock (and its copies) is the only data structure in btrfs which has a
fixed location on a device. Since we cannot overwrite in a sequential write
required zone, we cannot place superblock in the zone. One easy solution is
limiting superblock and copies to be placed only in conventional zones.
However, this method has two downsides: one is reduced number of superblock
copies. The location of the second copy of superblock is 256GB, which is in
a sequential write required zone on typical devices in the market today.
So, the number of superblock and copies is limited to be two. Second
downside is that we cannot support devices which have no conventional zones
at all.
To solve these two problems, we employ superblock log writing. It uses two
zones as a circular buffer to write updated superblocks. Once the first
zone is filled up, start writing into the second buffer. Then, when the
both zones are filled up and before start writing to the first zone again,
it reset the first zone.
We can determine the position of the latest superblock by reading write
pointer information from a device. One corner case is when the both zones
are full. For this situation, we read out the last superblock of each
zone, and compare them to determine which zone is older.
The following zones are reserved as the circular buffer on ZONED btrfs.
- The primary superblock: zones 0 and 1
- The first copy: zones 16 and 17
- The second copy: zones 1024 or zone at 256GB which is minimum, and next
to it
If these reserved zones are conventional, superblock is written fixed at
the start of the zone without logging.
<snip>
/*
* This is only the first step towards a full-features scrub. It reads all
@@ -3704,6 +3705,8 @@ static noinline_for_stack int scrub_supers(struct scrub_ctx *sctx,
if (bytenr + BTRFS_SUPER_INFO_SIZE >
scrub_dev->commit_total_bytes)
break;
+ if (!btrfs_check_super_location(scrub_dev, bytenr))
+ continue;
Any reason in particular we're skipping scrubbing supers here? Can't we just
lookup the bytenr and do the right thing here?
ret = scrub_pages(sctx, bytenr, BTRFS_SUPER_INFO_SIZE, bytenr,
scrub_dev, BTRFS_EXTENT_FLAG_SUPER, gen, i,
diff --git a/fs/btrfs/volumes.c b/fs/btrfs/volumes.c
index 10827892c086..db884b96a5ea 100644
--- a/fs/btrfs/volumes.c
+++ b/fs/btrfs/volumes.c
@@ -1282,7 +1282,8 @@ void btrfs_release_disk_super(struct btrfs_super_block *super)
}
static struct btrfs_super_block *btrfs_read_disk_super(struct block_device *bdev,
- u64 bytenr)
+ u64 bytenr,
+ u64 bytenr_orig)
{
struct btrfs_super_block *disk_super;
struct page *page;
@@ -1313,7 +1314,7 @@ static struct btrfs_super_block *btrfs_read_disk_super(struct block_device *bdev
/* align our pointer to the offset of the super block */
disk_super = p + offset_in_page(bytenr);
- if (btrfs_super_bytenr(disk_super) != bytenr ||
+ if (btrfs_super_bytenr(disk_super) != bytenr_orig ||
btrfs_super_magic(disk_super) != BTRFS_MAGIC) {
btrfs_release_disk_super(p);
return ERR_PTR(-EINVAL);
@@ -1348,7 +1349,8 @@ struct btrfs_device *btrfs_scan_one_device(const char *path, fmode_t flags,
bool new_device_added = false;
struct btrfs_device *device = NULL;
struct block_device *bdev;
- u64 bytenr;
+ u64 bytenr, bytenr_orig;
+ int ret;
lockdep_assert_held(&uuid_mutex);
@@ -1358,14 +1360,18 @@ struct btrfs_device *btrfs_scan_one_device(const char *path, fmode_t flags,
* So, we need to add a special mount option to scan for
* later supers, using BTRFS_SUPER_MIRROR_MAX instead
*/
- bytenr = btrfs_sb_offset(0);
flags |= FMODE_EXCL;
bdev = blkdev_get_by_path(path, flags, holder);
if (IS_ERR(bdev))
return ERR_CAST(bdev);
- disk_super = btrfs_read_disk_super(bdev, bytenr);
+ bytenr_orig = btrfs_sb_offset(0);
+ ret = btrfs_sb_log_location_bdev(bdev, 0, READ, &bytenr);
+ if (ret)
+ return ERR_PTR(ret);
+
+ disk_super = btrfs_read_disk_super(bdev, bytenr, bytenr_orig);
if (IS_ERR(disk_super)) {
device = ERR_CAST(disk_super);
goto error_bdev_put;
@@ -2029,6 +2035,11 @@ void btrfs_scratch_superblocks(struct btrfs_fs_info *fs_info,
if (IS_ERR(disk_super))
continue;
+ if (bdev_is_zoned(bdev)) {
+ btrfs_reset_sb_log_zones(bdev, copy_num);
+ continue;
+ }
+
memset(&disk_super->magic, 0, sizeof(disk_super->magic));
page = virt_to_page(disk_super);
diff --git a/fs/btrfs/zoned.c b/fs/btrfs/zoned.c
index ae509699da14..d5487cba203b 100644
--- a/fs/btrfs/zoned.c
+++ b/fs/btrfs/zoned.c
@@ -20,6 +20,25 @@ static int copy_zone_info_cb(struct blk_zone *zone, unsigned int idx,
return 0;
}
+static int sb_write_pointer(struct block_device *bdev, struct blk_zone *zone,
+ u64 *wp_ret);
+
+static inline u32 sb_zone_number(u8 shift, int mirror)
+{
+ ASSERT(mirror < BTRFS_SUPER_MIRROR_MAX);
+
+ switch (mirror) {
+ case 0:
+ return 0;
+ case 1:
+ return 16;
+ case 2:
+ return min(btrfs_sb_offset(mirror) >> shift, 1024ULL);
+ }
+
Can we get a comment here explaining the zone numbers?
+ return 0;
+}
+
static int btrfs_get_dev_zones(struct btrfs_device *device, u64 pos,
struct blk_zone *zones, unsigned int *nr_zones)
{
@@ -123,6 +142,49 @@ int btrfs_get_dev_zone_info(struct btrfs_device *device)
goto out;
}
+ /* validate superblock log */
+ nr_zones = 2;
+ for (i = 0; i < BTRFS_SUPER_MIRROR_MAX; i++) {
+ u32 sb_zone = sb_zone_number(zone_info->zone_size_shift, i);
+ u64 sb_wp;
+
I'd rather see
#define BTRFS_NR_ZONED_SB_ZONES 2
or something equally poorly named and use that instead of our magic 2 everywhere.
Then you can just do
int index = i * BTRFS_NR_ZONED_SB_ZONES;
&zone_info->sb_zones[index];
<snip>
+static int sb_log_location(struct block_device *bdev, struct blk_zone *zones,
+ int rw, u64 *bytenr_ret)
+{
+ u64 wp;
+ int ret;
+
+ if (zones[0].type == BLK_ZONE_TYPE_CONVENTIONAL) {
+ *bytenr_ret = zones[0].start << SECTOR_SHIFT;
+ return 0;
+ }
+
+ ret = sb_write_pointer(bdev, zones, &wp);
+ if (ret != -ENOENT && ret < 0)
+ return ret;
+
+ if (rw == WRITE) {
+ struct blk_zone *reset = NULL;
+
+ if (wp == zones[0].start << SECTOR_SHIFT)
+ reset = &zones[0];
+ else if (wp == zones[1].start << SECTOR_SHIFT)
+ reset = &zones[1];
+
+ if (reset && reset->cond != BLK_ZONE_COND_EMPTY) {
+ ASSERT(reset->cond == BLK_ZONE_COND_FULL);
+
+ ret = blkdev_zone_mgmt(bdev, REQ_OP_ZONE_RESET,
+ reset->start, reset->len,
+ GFP_NOFS);
What happens if we crash right after this? Is the WP set to the start of the
zone here? Does this mean we'll simply miss the super block? I understand
we're resetting one zone here, but we're doing this in order, so we'll reset one
and write one, then reset the other and write the next. We don't wait until
we've issued the writes for everything, so it appears to me that there's a gap
where we could have the WP pointed at the start of the zone, which we view as an
invalid state and thus won't be able to mount the file system. Or am I missing
something? Thanks,
Josef
