Re: [RFC PATCH 0/8] memcg: Enable fine-grained per process memory control

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Aug 18, 2020 at 11:26:17AM +0200, Michal Hocko wrote:
> On Tue 18-08-20 11:14:53, Peter Zijlstra wrote:
> > On Mon, Aug 17, 2020 at 10:08:23AM -0400, Waiman Long wrote:
> > > Memory controller can be used to control and limit the amount of
> > > physical memory used by a task. When a limit is set in "memory.high" in
> > > a v2 non-root memory cgroup, the memory controller will try to reclaim
> > > memory if the limit has been exceeded. Normally, that will be enough
> > > to keep the physical memory consumption of tasks in the memory cgroup
> > > to be around or below the "memory.high" limit.
> > > 
> > > Sometimes, memory reclaim may not be able to recover memory in a rate
> > > that can catch up to the physical memory allocation rate. In this case,
> > > the physical memory consumption will keep on increasing. 
> > 
> > Then slow down the allocator? That's what we do for dirty pages too, we
> > slow down the dirtier when we run against the limits.
> 
> This is what we actually do. Have a look at mem_cgroup_handle_over_high.

But then how can it run-away like Waiman suggested?

/me goes look... and finds MEMCG_MAX_HIGH_DELAY_JIFFIES.

That's a fail... :-(



[Index of Archives]     [Linux Ext4 Filesystem]     [Union Filesystem]     [Filesystem Testing]     [Ceph Users]     [Ecryptfs]     [AutoFS]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux Cachefs]     [Reiser Filesystem]     [Linux RAID]     [Samba]     [Device Mapper]     [CEPH Development]

  Powered by Linux