On Mon, Nov 15, 2021 at 08:49:41AM +0000, Roberto Sassu wrote: > > From: Eric Biggers [mailto:ebiggers@xxxxxxxxxx] > > Sent: Friday, November 12, 2021 8:12 PM > > On Fri, Nov 12, 2021 at 01:44:11PM +0100, Roberto Sassu wrote: > > > Make the necessary modifications to support fsverity in tmpfs. > > > > > > First, implement the fsverity operations (in a similar way of f2fs). These > > > operations make use of shmem_read_mapping_page() instead of > > > read_mapping_page() to handle the case where the page has been swapped > > out. > > > The fsverity descriptor is placed at the end of the file and its location > > > is stored in an xattr. > > > > > > Second, implement the ioctl operations to enable, measure and read fsverity > > > metadata. > > > > > > Lastly, add calls to fsverity functions, to ensure that fsverity-relevant > > > operations are checked and handled by fsverity (file open, attr set, inode > > > evict). > > > > > > Fsverity support can be enabled through the kernel configuration and > > > remains enabled by default for every tmpfs filesystem instantiated (there > > > should be no overhead, unless fsverity is enabled for a file). > > > > > > Signed-off-by: Roberto Sassu <roberto.sassu@xxxxxxxxxx> > > > > I don't see how this makes sense at all. The point of fs-verity is to avoid > > having to hash the whole file when verifying it. However, obviously the whole > > file still has to be hashed to build the Merkle tree in the first place. That > > makes sense for a persistent filesystem where a file can be written once and > > verified many times. I don't see how it makes sense for tmpfs, where files have > > to be re-created on every boot. You might as well just hash the whole file. > > The point of adding fsverity support for tmpfs was to being able to do > integrity enforcement with just one mechanism, given that I was > planning to do integrity verification with reference values loaded > to the kernel with DIGLIM [1]. > > With an LSM such as IPE [2], integrity verification would consist in > querying the fsverity digest with DIGLIM and allowing the operation > if the digest was found. With fsverity support in tmpfs, this can be > done from the very beginning of the boot process. > > Using regular file digests would be also possible but this requires > loading with DIGLIM both fsverity and non-fsverity reference values. > It would also require two separate mechanisms for calculating > the file digest depending on the filesystem. It could be done, but > I thought it was easier to add support for fsverity in tmpfs. > > > Also, you didn't implement actually verifying the data (by calling > > fsverity_verify_page()), so this patch doesn't really do anything anyway. > > Yes, at the end I didn't add it. Probably the only place where > calling fsverity_verify_page() would make sense is when a page > is swapped in (assuming that the swap device is untrusted). > > I tried to add a call in shmem_swapin_page() but fsverity complained > due to the fact that the page was already up to date, and also > rejected the page. I will check it better. > It sounds like you really only care about calculating fs-verity file digests. That's just an algorithm for hashing a file, so it could just be implemented in generic code that operates on any file on any filesystem, like how IMA implemennts full file hashing for any file. There isn't a need for any special filesystem support to do this. - Eric
![]() |