Hi Tom,
On 1/25/21 4:56 PM, Tom Rix wrote:
On 1/25/21 12:56 PM, richard.gong@xxxxxxxxxxxxxxx wrote:
From: Richard Gong <richard.gong@xxxxxxxxx>
Add COMMAND_AUTHENTICATE_BITSTREAM command flag for new added bitstream
authentication feature. Authenticating a bitstream is to make sure a signed
bitstream has the valid signatures.
Except for the actual configuration of the device, the bitstream
authentication works the same way as FPGA configuration does. If the
authentication passes, the signed bitstream will be programmed into QSPI
flash memory and will be expected to boot without issues.
Clean up COMMAND_RECONFIG_FLAG_PARTIAL flag by resetting it to 0, which
aligns with the firmware settings.
Signed-off-by: Richard Gong <richard.gong@xxxxxxxxx>
---
v3: no change
v2: new added
---
include/linux/firmware/intel/stratix10-svc-client.h | 11 ++++++++---
1 file changed, 8 insertions(+), 3 deletions(-)
diff --git a/include/linux/firmware/intel/stratix10-svc-client.h b/include/linux/firmware/intel/stratix10-svc-client.h
index ebc2956..7ada1f2 100644
--- a/include/linux/firmware/intel/stratix10-svc-client.h
+++ b/include/linux/firmware/intel/stratix10-svc-client.h
@@ -51,12 +51,17 @@
#define SVC_STATUS_NO_SUPPORT 6
/*
This patch fails to apply, i believe the conflict is because in mainline this is '/**' not '/*'
Please check or point me at the branch/tag you are using.
I am using next-20210125 tag.
I am using char-misc-next.
Tom
Tom
Regards,
Richard
