Hi Jean
Would you please help to review these 5 patches when you have
time, thanks very much.
Thanks
2013/7/29 Jett.Zhou <jtzhou@xxxxxxxxxxx>:
> From: Guoqing Li <ligq@xxxxxxxxxxx>
>
> We could set rb swap in two modules: DMA controler input part and
> dsi interface output part.
> DMA input part is based on pix_fmt to set rbswap, dsi output interface
> part will set rbswap based on platform dsi_rbswap configuration.
>
> This patch include below change and enhancement:
>
> 1) The input format which support rbswap is based on RGB format,
> eg. RGB565 indicates the source data in memory is that Red is [15~11],
> Green is [10~5], Blue is [4:0], Red is MSB, Blue is LSB, but for the
> display dma input default setting(rbswap = 0), it only support Blue
> is [15~11], Green is [10~5], Red is [4:0], Red is LSB, Blue is MSB,
> so for this format(RGB565), display controller need to set rbswap
> = 1 and it can support the MSB/LSB correctly.
> BGR/YUV format will not set it in mmp display driver.
>
> 2) The dsi output part of rbswap is depend on dsi_rbswap which is
> defined in specific platfrom. For output dsi interface, it has this
> feature to do rbswap again if it needs specifc byte sequence of RGB
> byte for DSI panel.
> eg. If display content is set RGB565 in memory and DMA input part set
> rbswap in driver to support Red as MSB , Blue LSB, but dsi panel only
> support Red as LSB, Blue as MSB, then it can use this feature.
> If there is no this requirement of panel, this dsi output part is not
> needed.
>
> Signed-off-by: Guoqing Li <ligq@xxxxxxxxxxx>
> Signed-off-by: Jett.Zhou <jtzhou@xxxxxxxxxxx>
> Reviewed-by: Daniel Drake <dsd@xxxxxxxxxx>
> ---
> drivers/video/mmp/hw/mmp_ctrl.c | 19 +++++++++++--------
> drivers/video/mmp/hw/mmp_ctrl.h | 5 +++++
> include/video/mmp_disp.h | 1 +
> 3 files changed, 17 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/video/mmp/hw/mmp_ctrl.c b/drivers/video/mmp/hw/mmp_ctrl.c
> index 75dca19..a40d95a 100644
> --- a/drivers/video/mmp/hw/mmp_ctrl.c
> +++ b/drivers/video/mmp/hw/mmp_ctrl.c
> @@ -60,8 +60,7 @@ static irqreturn_t ctrl_handle_irq(int irq, void *dev_id)
>
> static u32 fmt_to_reg(struct mmp_overlay *overlay, int pix_fmt)
> {
> - u32 link_config = path_to_path_plat(overlay->path)->link_config;
> - u32 rbswap, uvswap = 0, yuvswap = 0,
> + u32 rbswap = 0, uvswap = 0, yuvswap = 0,
> csc_en = 0, val = 0,
> vid = overlay_is_vid(overlay);
>
> @@ -71,27 +70,23 @@ static u32 fmt_to_reg(struct mmp_overlay *overlay, int pix_fmt)
> case PIXFMT_RGB888PACK:
> case PIXFMT_RGB888UNPACK:
> case PIXFMT_RGBA888:
> - rbswap = !(link_config & 0x1);
> + rbswap = 1;
> break;
> case PIXFMT_VYUY:
> case PIXFMT_YVU422P:
> case PIXFMT_YVU420P:
> - rbswap = link_config & 0x1;
> uvswap = 1;
> break;
> case PIXFMT_YUYV:
> - rbswap = link_config & 0x1;
> yuvswap = 1;
> break;
> default:
> - rbswap = link_config & 0x1;
> break;
> }
>
> switch (pix_fmt) {
> case PIXFMT_RGB565:
> case PIXFMT_BGR565:
> - val = 0;
> break;
> case PIXFMT_RGB1555:
> case PIXFMT_BGR1555:
> @@ -248,7 +243,8 @@ static void path_set_mode(struct mmp_path *path, struct mmp_mode *mode)
> {
> struct lcd_regs *regs = path_regs(path);
> u32 total_x, total_y, vsync_ctrl, tmp, sclk_src, sclk_div,
> - link_config = path_to_path_plat(path)->link_config;
> + link_config = path_to_path_plat(path)->link_config,
> + dsi_rbswap = path_to_path_plat(path)->link_config;
>
> /* FIXME: assert videomode supported */
> memcpy(&path->mode, mode, sizeof(struct mmp_mode));
> @@ -263,6 +259,12 @@ static void path_set_mode(struct mmp_path *path, struct mmp_mode *mode)
> tmp |= CFG_DUMB_ENA(1);
> writel_relaxed(tmp, ctrl_regs(path) + intf_ctrl(path->id));
>
> + /* interface rb_swap setting */
> + tmp = readl_relaxed(ctrl_regs(path) + intf_rbswap_ctrl(path->id)) &
> + (~(CFG_INTFRBSWAP_MASK));
> + tmp |= dsi_rbswap & CFG_INTFRBSWAP_MASK;
> + writel_relaxed(tmp, ctrl_regs(path) + intf_rbswap_ctrl(path->id));
> +
> writel_relaxed((mode->yres << 16) | mode->xres, ®s->screen_active);
> writel_relaxed((mode->left_margin << 16) | mode->right_margin,
> ®s->screen_h_porch);
> @@ -419,6 +421,7 @@ static int path_init(struct mmphw_path_plat *path_plat,
> path_plat->path = path;
> path_plat->path_config = config->path_config;
> path_plat->link_config = config->link_config;
> + path_plat->dsi_rbswap = config->dsi_rbswap;
> path_set_default(path);
>
> kfree(path_info);
> diff --git a/drivers/video/mmp/hw/mmp_ctrl.h b/drivers/video/mmp/hw/mmp_ctrl.h
> index edd2002..53301cf 100644
> --- a/drivers/video/mmp/hw/mmp_ctrl.h
> +++ b/drivers/video/mmp/hw/mmp_ctrl.h
> @@ -163,6 +163,8 @@ struct lcd_regs {
>
> #define LCD_SCLK(path) ((PATH_PN == path->id) ? LCD_CFG_SCLK_DIV :\
> ((PATH_TV == path->id) ? LCD_TCLK_DIV : LCD_PN2_SCLK_DIV))
> +#define intf_rbswap_ctrl(id) ((id) ? (((id) & 1) ? LCD_TVIF_CTRL : \
> + PN2_IOPAD_CONTROL) : LCD_TOP_CTRL)
>
> /* dither configure */
> #ifdef CONFIG_CPU_PXA988
> @@ -615,6 +617,8 @@ struct lcd_regs {
> #define LCD_SPU_DUMB_CTRL 0x01B8
> #define CFG_DUMBMODE(mode) ((mode)<<28)
> #define CFG_DUMBMODE_MASK 0xF0000000
> +#define CFG_INTFRBSWAP(mode) ((mode)<<24)
> +#define CFG_INTFRBSWAP_MASK 0x0F000000
> #define CFG_LCDGPIO_O(data) ((data)<<20)
> #define CFG_LCDGPIO_O_MASK 0x0FF00000
> #define CFG_LCDGPIO_ENA(gpio) ((gpio)<<12)
> @@ -1427,6 +1431,7 @@ struct mmphw_path_plat {
> struct mmp_path *path;
> u32 path_config;
> u32 link_config;
> + u32 dsi_rbswap;
> };
>
> /* mmp ctrl describes mmp controller related info */
> diff --git a/include/video/mmp_disp.h b/include/video/mmp_disp.h
> index b9dd1fb..32094c0 100644
> --- a/include/video/mmp_disp.h
> +++ b/include/video/mmp_disp.h
> @@ -334,6 +334,7 @@ struct mmp_mach_path_config {
> int output_type;
> u32 path_config;
> u32 link_config;
> + u32 dsi_rbswap;
> };
>
> struct mmp_mach_plat_info {
> --
> 1.7.0.4
>
--
----------------------------------
Best Regards
Jett Zhou
--
To unsubscribe from this list: send the line "unsubscribe linux-fbdev" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
