> On Fri, Jun 28, 2013 at 2:28 PM, Fabio Estevam <festevam@xxxxxxxxx> wrote:
> > Hi Philipp/Sascha,
> >
> > When I enable the parallel display on a mx53qsb, I noticed that fbset
> > does not report the correct information:
> >
> > mode "800x480-0"
> > # D: 0.000 MHz, H: 0.000 kHz, V: 0.000 Hz
> > geometry 800 480 800 480 16
> > timings 0 0 0 0 0 0 0
>
> Ok, just realized that my host PC reports the same in the 'timings' line.
>
> So not an issue with the imx-drm driver then.
"800x480-0"
Mode should contain vertical frequency, like 800x480-50.
Zero is not valid here, is not it?
---
��.n��������+%������w��{.n�����{����n�r������&��z�ޗ�zf���h���~����������_��+v���)ߣ�
