Don't reset the sink power to D0. Removing this for three reasons: 1) It's not required in the SW link training documentation 2) The comment is incorrect, D0 is normal operation, not "power down" 3) It seems to change things in the link training that causes glitches Signed-off-by: Sean Paul <seanpaul@xxxxxxxxxxxx> --- drivers/video/exynos/exynos_dp_core.c | 6 ------ 1 files changed, 0 insertions(+), 6 deletions(-) diff --git a/drivers/video/exynos/exynos_dp_core.c b/drivers/video/exynos/exynos_dp_core.c index 207bd7e..1c998d9 100644 --- a/drivers/video/exynos/exynos_dp_core.c +++ b/drivers/video/exynos/exynos_dp_core.c @@ -273,12 +273,6 @@ static int exynos_dp_link_start(struct exynos_dp_device *dp) for (lane = 0; lane < lane_count; lane++) dp->link_train.cr_loop[lane] = 0; - /* Set sink to D0 (Sink Not Ready) mode. */ - ret = exynos_dp_write_byte_to_dpcd(dp, DPCD_ADDR_SINK_POWER_STATE, - DPCD_SET_POWER_STATE_D0); - if (ret) - return ret; - /* Set link rate and count as you want to establish*/ exynos_dp_set_link_bandwidth(dp, dp->link_train.link_rate); exynos_dp_set_lane_count(dp, dp->link_train.lane_count); -- 1.7.7.3 -- To unsubscribe from this list: send the line "unsubscribe linux-fbdev" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
