Hi Tomi,
On 2/14/2012 12:57 PM, Tomi Valkeinen wrote:
Hi,
On Fri, 2012-02-10 at 11:45 +0530, Archit Taneja wrote:
For DSS clock domain to transition from idle to active state. It's necessary
to enable the optional clock DSS_FCLK before we enable the module using the
MODULEMODE bits in the clock domain's CM_DSS_DSS_CLKCTRL register.
This sequence was not followed correctly for the 'dss_hdmi' hwmod and it led
to DSS clock domain not getting out of idle when pm_runtime_get_sync() was
called for hdmi's platform device.
Since the clock domain failed to change it's state to active, the hwmod code
disables any clocks it had enabled before for this hwmod. This led to the clock
'dss_48mhz_clk' gettind disabled.
When hdmi's runtime_resume() op is called, the call to dss_runtime_get()
correctly enables the DSS clock domain this time. However, the clock
'dss_48mhz_clk' is needed for HDMI's PHY to function correctly. Since it was
disabled previously, the driver fails when it tries to enable HDMI's PHY.
Fix this for now by ensuring that dss_runtime_get() is called before we call
pm_runtime_get_sync() for hdmi's platform device. A correct fix for later would
be to modify the DSS related hwmod's mainclks, and also some changes in how
opt clocks are handled in the DSS driver.
This fixes the issue of HDMI not working when it's the default display. The
issue is not seen if any other display is already enabled as the first display
would have correctly enabled the DSS clockdomain.
I think this looks fine, it's shouldn't have any side effects and is
easy to remove later.
Benoit, do you think we'll get the MODULEMODE mess cleaned up in the
hwmod/clk framework at some point, and the drivers could do without
these kinds of hacks? =)
The best way to fix that for my point of view is to go to device tree
or/and to consider the DSS as the parent of all the DSS modules.
pm_runtime will then always ensure that the parent is enabled before any
of the child are used.
Implementing that with hwmod is not the right approach since is will
require to add some more complex OMAP custom stuff in the hwmod fmwk
whereas the LDM is already able to handle that.
The whole point is that going to device tree, we will have to change the
responsibility of hwmod to make it focus mainly on OMAP PRCM stuff and
let the device handles the IRQ/DMA/REG/CLKS resources since it is the
correct place to do that.
Regards,
Benoit
--
To unsubscribe from this list: send the line "unsubscribe linux-fbdev" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
