viafb: reduce viafb_set_iga_path usage The result of viafb_set_iga_path can change after init only in the hotplug ioctl. So we can move it there rather than doing it always when a new mode is set. The setup during init is done via a call from the init chip funtion. This change enables a stable mapping between the old device scheme and a new more powerfull one. Signed-off-by: Florian Tobias Schandinat <FlorianSchandinat@xxxxxx> Cc: Joseph Chan <JosephChan@xxxxxxxxxx> --- drivers/video/via/hw.c | 1 - drivers/video/via/ioctl.c | 2 ++ 2 files changed, 2 insertions(+), 1 deletions(-) diff --git a/drivers/video/via/hw.c b/drivers/video/via/hw.c index 4407943..638cf96 100644 --- a/drivers/video/via/hw.c +++ b/drivers/video/via/hw.c @@ -2313,7 +2313,6 @@ int viafb_setmode(struct VideoModeTable *vmode_tbl, int video_bpp, via_write_reg(VIASR, i, VPIT.SR[i - 1]); viafb_write_reg_mask(0x15, VIASR, 0xA2, 0xA2); - viafb_set_iga_path(); /* Write CRTC */ viafb_fill_crtc_timing(crt_timing, vmode_tbl, video_bpp / 8, IGA1); diff --git a/drivers/video/via/ioctl.c b/drivers/video/via/ioctl.c index da03c07..455b39f 100644 --- a/drivers/video/via/ioctl.c +++ b/drivers/video/via/ioctl.c @@ -92,6 +92,7 @@ int viafb_ioctl_hotplug(int hres, int vres, int bpp) viafb_CRT_ON = 0; viafb_LCD_ON = 0; viafb_DeviceStatus = DVI_Device; + viafb_set_iga_path(); return viafb_DeviceStatus; } status = 1; @@ -105,6 +106,7 @@ int viafb_ioctl_hotplug(int hres, int vres, int bpp) viafb_LCD_ON = 0; viafb_DeviceStatus = CRT_Device; + viafb_set_iga_path(); return viafb_DeviceStatus; } -- 1.6.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-fbdev" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
