Hi, Ivan, Do you want use mkfs.ext2 to make a small ext2 image file and write the image to mmc or some devices? when you write it to block device, the tool can modify the sb info about the file system size? for example: You must cost 60s to write a 64MB ext2 image You want to make a 8MB ext2 image So you can cost little time to write image to block device and use 64MB partition space? Is this? Best Regards? 2011/8/18 Ted Ts'o <tytso@xxxxxxx>: > On Thu, Aug 18, 2011 at 01:50:48AM +0700, Ivan Shmakov wrote: >> >>>>> Ted Ts'o <tytso@xxxxxxx> writes: >> >>>>> On Tue, Aug 16, 2011 at 06:37:23PM +0700, Ivan Shmakov wrote: >> >> >> How do I get the Ext2+ filesystem size (in blocks)? >> >> > I assume you need the exact numbers, so you can't use statfs(2)? >> > What are you using it for? >> >> The intent is to process a filesystem image, not a mounted >> filesystem. It's my understanding that I cannot use neither >> statfs(2) nor POSIX' statvfs(2) in this case. >> >> The code I've posted earlier is used in my e2dis [1–3] project. > > For this, I'd suggest that you use the ext2fs library. That will take > care of byte swapping, etc. It also means that you don't have to > worry about parsing the extent trees. If you had used the ext2fs > library before ext4 had shipped, you wouldn't have had to make any > changes to support extents, since the ext2fs library wraps and > provides abstract interfaces for most of what you would need for e2dis > project. > > Regards, > > - Ted > -- > To unsubscribe from this list: send the line "unsubscribe linux-ext4" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe linux-ext4" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html