While attempting to send ARP DAD packets on a bridge device, I noticed that hosts attached to the bridge ports were not responding. After digging in with tcpdump/wireshark, I noticed that the MAC addresses of the packets (the first 12 bytes of the Ethernet frame) were wrong and were an exact duplicate of the following 12 bytes (bytes 13-24), but only on slave bridge ports. The bridge device itself had the correct addresses. Here is an example setup:
# ip link add br0 type bridge vlan_filtering 1
--
Brandon Carpenter | Software Engineer
Cypherpath, Inc.
400 Columbia Point Drive Ste 101 | Richland, Washington USA
Office: (650) 713-3060
CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain proprietary, confidential or privileged information or otherwise be protected by law. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please notify the sender and destroy all copies and the original message.
