On Mon, 18 Oct 2010 19:16:18 -0700 Thomas Taranowski <tom@xxxxxxxxxxxxxxx> wrote: > I have bridged eth0 and eth1, where eth0 is the world, and eth1 has > some locally administered targets with normal IPs. On eth1, I also > have some other devices with 192.168.x.x addresses I locally assigned. > I'd like to give my eth1 a 192.168.x.x address, and treat the > 192.168.x.x network as something like a local network, where anything > else get's bridged across to eth0. I'm running into some problems. > > First, when I try to ping anything on the 192.168.x.x network, it > get's sent out the wrong interface ( eth0 ), rather than eth1. I > expected the bridge to broadcast the arp request to both interfaces. > > Second, giving eth1 an ip address, in addition to being bridged, had > no obvious effect. Can I even do this? > > Any suggestions on where to look for additional information on this, > or things to try? Don't put IP address on only one interface unless you are setting up a brouter[1]. If you want to do firewalling then add ebtables rules to block traffic; doing firewalling with addressing won't work because the address won't be accessible as you found out. 1. A brouter requires additional ebtables to make packets flow. _______________________________________________ Bridge mailing list Bridge@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/bridge
