Jiri Pirko a écrit : > [PATCH net-next] bonding: allow bond in mode balance-alb to work properly in bridge -try4.3 > > (updated) > changes v4.2 -> v4.3 > - memcpy the address always, not just in case it differs from master->dev_addr > - compare_ether_addr_64bits() is not used so there is no direct need to make new > header file (I think it would be good to have bond stuff in separate file > anyway). Yes, this could be done in a future cleanup patch. I find this (short) version easier to review for a new feature. Signed-off-by: Eric Dumazet <eric.dumazet@xxxxxxxxx> > > changes v4.1 -> v4.2 > - use skb->pkt_type == PACKET_HOST compare rather then comparing skb dest addr > against skb->dev->dev_addr > > Hi all. > > The problem is described in following bugzilla: > https://bugzilla.redhat.com/show_bug.cgi?id=487763 > > Basically here's what's going on. In every mode, bonding interface uses the same > mac address for all enslaved devices (except fail_over_mac). Only balance-alb > will simultaneously use multiple MAC addresses across different slaves. When you > put this kind of bond device into a bridge it will only add one of mac adresses > into a hash list of mac addresses, say X. This mac address is marked as local. > But this bonding interface also has mac address Y. Now then packet arrives with > destination address Y, this address is not marked as local and the packed looks > like it needs to be forwarded. This packet is then lost which is wrong. > > Notice that interfaces can be added and removed from bond while it is in bridge. > > *** > When the multiple addresses for bridge port approach failed to solve this issue > due to STP I started to think other way to solve this. I returned to previous > solution but tweaked one. > > This patch solves the situation in the bonding without touching bridge code. > For every incoming frame to bonding the destination address is compared to > current address of the slave device from which tha packet came. If these two > match destination address is replaced by mac address of the master. This address > is known by bridge so it is delivered properly. Note that the comparsion is not > made directly, it's used skb->pkt_type == PACKET_HOST instead. This is "set" > previously in eth_type_trans(). > > I experimentally tried that this works as good as searching through the slave > list (v4 of this patch). > > Jirka > > > Signed-off-by: Jiri Pirko <jpirko@xxxxxxxxxx> > > diff --git a/include/linux/netdevice.h b/include/linux/netdevice.h > index 371ece5..9b4db94 100644 > --- a/include/linux/netdevice.h > +++ b/include/linux/netdevice.h > @@ -1920,6 +1920,16 @@ static inline void netif_set_gso_max_size(struct net_device *dev, > dev->gso_max_size = size; > } > > +static inline void skb_bond_set_mac_by_master(struct sk_buff *skb, > + struct net_device *master) > +{ > + if (skb->pkt_type == PACKET_HOST) { > + u16 *dest = (u16 *) eth_hdr(skb)->h_dest; > + > + memcpy(dest, master->dev_addr, ETH_ALEN); > + } > +} > + > /* On bonding slaves other than the currently active slave, suppress > * duplicates except for 802.3ad ETH_P_SLOW, alb non-mcast/bcast, and > * ARP on active-backup slaves with arp_validate enabled. > @@ -1933,6 +1943,14 @@ static inline int skb_bond_should_drop(struct sk_buff *skb) > if (master->priv_flags & IFF_MASTER_ARPMON) > dev->last_rx = jiffies; > > + if ((master->priv_flags & IFF_MASTER_ALB) && master->br_port) { > + /* Do address unmangle. The local destination address > + * will be always the one master has. Provides the right > + * functionality in a bridge. > + */ > + skb_bond_set_mac_by_master(skb, master); > + } > + > if (dev->priv_flags & IFF_SLAVE_INACTIVE) { > if ((dev->priv_flags & IFF_SLAVE_NEEDARP) && > skb->protocol == __cpu_to_be16(ETH_P_ARP)) _______________________________________________ Bridge mailing list Bridge@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/bridge